GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

kodak photo share

Page 1 of 2 12 LastLast
  1. Delivering a load of oil , Rapid City , S.D.
  2. 100 0478
  3. Put some primer on so I could drive her , no putty yet .
  4. About a 2" piece to finish top of hood .
  5. Had to make this piece to finish top of hood . When I cut the hood and pulled it up to put sides on it ended up a little short at the back .
  6. Cowl induction hood all welded up , no putty yet .
  7. made this piece to cap off inside window post.
  8. inside window post or D pillar capped off.
  9. inside window post with wires showing.
  10. Bulkhead framework with seal.
  11. Framework around wheel well . I added these braces , just in case something slid into it.
  12. Bed corner at tailgate . The inside piece at weld on top is made to match tailgate closure . The end and inside piece where hand made  and bent to...
  13. Bulkhead and window
  14. bulkhead , right inside corner. It sits on the seals push on welting at the bottom and then pulls up against the bulb and is latched to seal it up.No...
  15. bulkhead side frames in place.
  16. side & rear view
  17. before  SUBURBAN
  18. after   AVABURB
Showing photos 1 to 18 of 30
Page 1 of 2 12 LastLast