
New PostsThanks guys I actually just got the seats back from the upholster. They look awesome ill be throwing them in later this week
ahmitchell1 Today, 03:12 PM
Backfiring through the carb is normally a timing issue, something's out of sync, doesnt take much.
With the new heads, and gaskets, did you verify
I was planning on heading up to my cousins and redo the plumbing so she could move back into her house, but thankfully someone else helped her. I was
imotto Today, 02:47 PM
I have a motor from a 1979 chevy pickup. recently i put on all new aluminum heads, intake ,108 cam,solid aluminum valve covers, bew double timing chain
1446Rich Today, 02:45 PM
i purchased a 2005 colorado 4 door, 5cyl 2 wheel drive only draw back so far, i had to install air bags on the rear, due to serious sagging when towing
marine59 Today, 02:43 PM
Can you get a good look at the pulley to see if its loose or possibly got a crack on the mounting face?
tbplus10 Today, 02:30 PM
My son's "battle cross" and some of his brothers.. 02/24/08. I will go and visit with him in the next couple of days, I miss him
National makes springs for big trucks mostly, guys doing monster truck builds with oversized axles use them a lot.
The Deevers on my truck are Chevy
Forum Links
• Technical Q & A
• Chevy Truck Forums
• Chevy SUV Forums
• Chevy Car & Other Forums
Member Forums
• Announcements
• Games & Contests
• Members Introductions
• Mods & Accessories
Like our Facebook Page
ROTM Pollpmf608 (4 Votes)
Enkeiavalanche (24 Votes)
Conlan Rose (4 Votes)
Pikey (3 Votes)

Too much oil pressure!! Need help
all the ports on the intake were dremaled wider i bought the whole top end as a kit. I used a oil priming kit that i ran on the oil pump while the distributer
1446Rich Today, 03:38 PM