Type: Posts; User: ericz
Search: Search took 0.00 seconds.
Thanks for the reply. Appreciate it.
I need to replace the drivers front wheel hub as the bearing is shot.
Passenger side is fine...
Here is my stupid question:
I was going to install a Timkin wheel hub rather than GM. As the wheel...
The oil pump was on the block when I purchased it. I will look at that today.
Thanks for the replies.
I am assembling a 1985 350 engine. I picked up someone else's failed project, so some of then work was completed.
Heads and pistons were installed at a machine shop.
Anyway, the distributer does...
Thanks Dipstick. looks like you are correct.
I just found a parts diagram online. I will cap off the booster return.
I appreciate the help.
I am rebuilding a 350 that we think was from a 79 truck.
The power steering pump has 3 hoses on it. I expected 2....
Any suggestions on what to do with the 3rd hose?
I am still cleaning it off,...
The rotor is loose but being retained by something. Before I smack the hell out of it, i want to be sure I am not missing something simple.
18mm om my 2003 Yukon.
the rear passenger side rotor on my 2003 Yukon XL will not come off.
I believe the parking brake is not releasing far enough.
What is the proper way to adjust the parking brake?
I have a 2003 YukonXL with the standard radio/cd player.
Are there any aftermarket systems that work with the rear controls or do they become useless after an upgrade?
Will onstar still work?...
Rust has taken its toll on my 96 Suburban. I am looking at an 03 Yukon XL Denali.
How does the AWD system compare to the 4WD system?
Specifically, how does it perform in the sand?
I had a similar issue with a 96 Suburban. Vents were stuck on Defrost and there was no heat.
I replaced the HVAC control panel and it fixed both.
96 1/2 ton Suburban...
One of my rear brake lines rusted out last night. its the Passenger side line that runs across the axle to the drum.
I would like to order up some Tube today but...
This has happened to both of my back doors in my Suburban.
Pop off the door panel. You may have to unscrew the arm rest. In the Suburban, behind the door panel, there are some holes in the sheet...
My question is: how is the heat and vent selection controlled on a 1996 Suburban?
Is it electric or vacuum?
My vent is stuck in defrost and there is no heat. (I relied on the rear heat...
For those interested, the system is installed and working, sort of.
I think the color coded wires are a bit off. I woke up today with a low battery. It was down @ 11 volts.
I think the constant...
I am installing a Navigation system in my 96 Chevy Suburban.(350)
The system requires a connection to the Vehicle Speed Sensor.(VSS)
I believe I have identified the correct wire under...
Results 1 to 17 of 17