GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: 00chevy53

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    178

    Check out texas-speed.com for cam kits and other...

    Check out texas-speed.com for cam kits and other parts. Id say your on the right track just dont forget about needing a better oil pump like a ported ls6 one. Even a transmission pan that holds a...
  2. Replies
    4
    Views
    152

    i could see some guy with lots of money putting...

    i could see some guy with lots of money putting that on a rock crawler just because he can... lets face it anyone whos smart goes out with at least one other rig so this is pointless in my opinion
  3. Replies
    3
    Views
    188

    there are no torsion bars on a the 2wd drive...

    there are no torsion bars on a the 2wd drive trucks...
  4. Replies
    3
    Views
    188

    lowered to lifted

    So im stuck on this one guys. Cant figure out what im missing as far as a lowering part i havent taken off the front end to be able to clear the 33s the lift allows for. My biggest problem was i...
  5. Replies
    9
    Views
    451

    the heads will fit but like rayvoy said probably...

    the heads will fit but like rayvoy said probably wont do much..
  6. Replies
    6
    Views
    290

    check out texas-speed.com look at the packages...

    check out texas-speed.com look at the packages they put together and compare to what you have. i will say that you should upgrade your oil pump and you need to get new roller rockers for the new cam....
  7. like buckmeister2 said a custom tune will be the...

    like buckmeister2 said a custom tune will be the best bang for your buck. I had my truck tuned in Jacksonville Florida and go about 50hp increase other than the tune i installed an intake shorty...
  8. Replies
    3
    Views
    249

    ive never looked that deep into them but like i...

    ive never looked that deep into them but like i said with what you would spend on a dyno tune the flash tune kits are not worth it unless you have a diesel
  9. Replies
    3
    Views
    249

    Any real shop that does dyno tunes will turn off...

    Any real shop that does dyno tunes will turn off the sensors that are not needed with a catless exhaust system. Im not sure if any of the shops you send your stock computer to can do this, my only...
  10. your best bet is to call/email those companies...

    your best bet is to call/email those companies about warranties. i will say that lingenfelter doesn't tend to use lesser components. from my understanding the only difference between magnuson and...
  11. Thread: Camshaft 6.0

    by 00chevy53
    Replies
    3
    Views
    283

    check out what texas speed has to offer... they...

    check out what texas speed has to offer... they do real good deals on head and cam kits. If your going to do all that you may as well up grade your intake manifold
  12. Replies
    13
    Views
    1,168

    Dobey- 4.10 gears will only reach 202 with a...

    Dobey- 4.10 gears will only reach 202 with a motor pushing well over 500hp. My top speed with my setup now is 145mph. Gearing lower only gets you up to speed not top speed.

    If your truck is...
  13. Replies
    13
    Views
    1,168

    That's as simple as putting in a bigger stall...

    That's as simple as putting in a bigger stall converter and changing rear end gears... Your looking at about 3-500 for the stall alone.
  14. Replies
    13
    Views
    1,168

    Look into stainless brake lines and upgrade your...

    Look into stainless brake lines and upgrade your brake rotors as far as slotted or slotted and drilled... Summit racing should have all that for around $600... But as far as the power is concerned...
  15. Replies
    203
    Views
    38,374

    Sticky: 2000 Silverado race truck

    Been a while since I posted on here but this is one angle of the new look
  16. Had a similar issue a few years ago and is...

    Had a similar issue a few years ago and is probably your 02sensors going bad... Scan it to be sure but willing to bet 02 sensors is the culprit
  17. Replies
    2
    Views
    574

    After being parked next to many other lowered...

    After being parked next to many other lowered trucks where recent drops have been put on, mine sits at the same height as one with a 3/4.
  18. Replies
    2
    Views
    574

    Lowered to lifted...

    Well I'm looking into lifting my truck at least to stock if not a few inches over but the fun is from starting with a truck that's got a 3/4 drop on it from previous owner. Also I'm not sure what...
  19. I had my 4l60 built and wish I would have just...

    I had my 4l60 built and wish I would have just gone to 4l80, from what I understand it's not gonna handle much more than 450rwhp. A properly built 4l80 will get you up to 800 at least if not more
  20. I agree with darnie1987 you will need a new...

    I agree with darnie1987 you will need a new trans. The easiest thing to do is find a used 4l80e out of a 2500 and have that built to exactly what your. Looking to do with the truck.
  21. There is a shop in Fresno called all out...

    There is a shop in Fresno called all out performance. You should take a look at what they offer they built a silverado thats making about 600 hp to wheels and they did it with a completely stock...
  22. Well there's a lot that goes into figuring out...

    Well there's a lot that goes into figuring out what cam to get. If this is something your looking at doing your self you should look at getting this book off amazon called turbo charging performance...
  23. Replies
    3
    Views
    392

    Gas in California?

    So I'm just getting back to the states from an 8 month deployment at sea. What kind of gas prices am I gonna be looking at for 91 octane?
  24. Replies
    4
    Views
    1,546

    go check out texas-speed.com the site has a lot...

    go check out texas-speed.com the site has a lot of parts for gm trucks with ls based motors...
  25. Thread: R.i.p. 6.0

    by 00chevy53
    Replies
    2
    Views
    670

    R.i.p. 6.0

    well due to some bad luck my 6.0 is no longer running:erf:... so now its time to start looking for a replacement. what do you all think i should do? go bigger or get another 6.0 and punch it out to...
Results 1 to 25 of 157
Page 1 of 7 1 2 3 4