Type: Posts; User: Sportclmb
Search: Search took 0.00 seconds.
07-24-2010, 11:55 AM
You can purchase the stepper motors off ebay. And fix it yourself. I just did my 03 burb this morning took about an hour. Extremely easy if you can solder and de-solder. parts were 40$ off...
Just completed the change out of the stepper motors. It was incredibly simple if you know how to use a de-soldering tool and a soldering gun. Cost me a total of 40$ to change all the stepper...
All, I have an s-10 4 cyl manual 5 speed. All stock. Last week it began to act a little funny. On hard acceleration it backfires through the throttle body. Under light acceleration and idle it...
I had the same issue at low speeds. Chances are that the E-brake pads are shot and need to be replaced. They are located inside the rear disk rotors. I did mine recently it's extremely simple. On...
I've got a similar issue with my speedo. Going to replace the stepper motors as soon as I get them in. (ordered them off EBAY) I'll post how difficult/easy the change is.
07-20-2010, 10:38 AM
Sounds like a loose/broken connection. there are a couple of places to look for it. #1 is under the seat. The vehicle side harness should plug into a seat side harness, check that. Also...
I currently have a 03 surburban
Looking forward to helping out people and getting some assistance.
Sounds logical to me. That is where I would start assuming that the transmission fluid levels while hot are reading ok.
I've searched through the DB but I wasn't able to find this issue exactly. I have an issue with my 4wd selector switch. Each time you start the vehicle it doesn't remember the last setting. It...
I have an 03 burb. Will the cluster from a 2001 1500 directly swap? My 03 has a bad speedo. Happen to have an extra cluster from an 01.
Results 1 to 10 of 10