GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: wulk025

Search: Search took 0.00 seconds.

  1. Replies
    110
    Views
    29,834

    Sticky: how do you subscribe????

    how do you subscribe????
  2. Replies
    110
    Views
    29,834

    Sticky: Dang the link dont work. Is there another way to...

    Dang the link dont work. Is there another way to view the info?
  3. I’ve been a Mechanic for the last 12 years and...

    I’ve been a Mechanic for the last 12 years and the Vortech engine from 1996 -1999 is one of the hardest motors to diagnose when it comes to this problem. I just went through the steps of what is...
  4. White smoke = coolant - Blue smoke = oil - Black...

    White smoke = coolant - Blue smoke = oil - Black smoke =gas.
    Also check your spark plugs for fouling as you will be able to use the spark plug chart to determine what fluids are getting into your...
  5. Replies
    17
    Views
    4,559

    I would pull your distributer and check to see...

    I would pull your distributer and check to see how warn thesplines on the shaft. If they are good i would then check to see how yourtiming is set you might have it retarded which would cause bad gas...
  6. Sweet I got it fixed turned out to be the fuel...

    Sweet I got it fixed turned out to be the fuel pressure regulator. So if anyone out there is getting a code p1351 and you changed out you ignition control module check your fuel pressure regulator...
  7. Haven't looked at the fuel filter yet. I think...

    Haven't looked at the fuel filter yet. I think that the pressuer regulator is bad so im going to tear down the intake one more time and replace that.But I will need to wait till tomorrow I just...
  8. Replies
    8
    Views
    1,397

    It could be your weep hole in the water pump...

    It could be your weep hole in the water pump causing the issue. The seal in on the water pump shaft would be going bad causing the leak through the weep hole.
  9. Fuel Pressure @ 40psi PLEASE HELP IM LOSING MY MIND

    So this last weekend I started the tear down on my 1996 K2500 Sub 7.4L lower intake. I got it tore down and reassembled with new gaskets, distributer, and fuel rail. Got it to fire right up and run...
  10. Replies
    673
    Views
    70,110

    Just put 142,323 miles and had to put a new trans...

    Just put 142,323 miles and had to put a new trans in. 1996 Suburban
  11. Replies
    8
    Views
    3,036

    If your PCV valve is bad you could be pulling to...

    If your PCV valve is bad you could be pulling to much vacuum and sucking up oil into the intake.
  12. Replies
    19
    Views
    11,850

    Unless the burban has been running full synthetic...

    Unless the burban has been running full synthetic oil in it DO NOT use any full synthetic oil it will leak like crazy. Your oil pan, valve cover seal, and valve seats.
  13. Replies
    4
    Views
    5,960

    Ya new gasket and new bolts just in case the old...

    Ya new gasket and new bolts just in case the old ones were stressed but i doubt it with it only needing to be torqued to 10ft lb. I pulled the upper intake back off and checked the deck on the lower...
  14. Replies
    4
    Views
    5,960

    So i have the 7.4l and torqued it down to 120in...

    So i have the 7.4l and torqued it down to 120in lb or 10ft lb and the front left tab broke off of the upper intake:neutral:. I did start by torquing everything to 44in lb then went to 120in lb walked...
  15. Replies
    110
    Views
    29,834

    Sticky: The password no longer works.

    The password no longer works.
  16. Replies
    4
    Views
    5,960

    UPPER Plenum Intake Torque Setting

    So i removed my upper intake off my 1996 suburban to replace cap, rotor, coil, and control module. I cant find the torque setting for the upper bolts. Dose anybody know what the torque setting is for...
  17. Replies
    2
    Views
    1,067

    He's talking about how the motor cuts off 4...

    He's talking about how the motor cuts off 4 cylinders to save on gas at cruising speeds.
  18. Replies
    7
    Views
    1,925

    Well while towing you do put one hell of a load...

    Well while towing you do put one hell of a load on the motor and trany and it will retain more heat in the heart of the motor and tranny. try letting it idle for a min or two before shutting it down...
  19. Replies
    7
    Views
    1,517

    Well i run 37 in tire with 4.56 gears in the...

    Well i run 37 in tire with 4.56 gears in the front and rear diff and my 1996 Sub dose a great job pulling my 7000lb trailor and boat
  20. Replies
    16
    Views
    1,619

    Sorry it looks like its got a 8in lift and with...

    Sorry it looks like its got a 8in lift and with the 37in tires makes it look bigger I had to look over the paper work again took some time i haven seen the paper work sense 1997 found it in my file...
  21. Replies
    113
    Views
    16,685

    Poll: I always do my own oil change every 4000 miles...

    I always do my own oil change every 4000 miles with Full Synthetic 10w30 Valvoline. Lets me get a good look at the motor and belly of the Burban and tighten any bolts or screws and check the air...
  22. Replies
    673
    Views
    70,110

    132000 miles on my 1996 K2500 Suburban

    132000 miles on my 1996 K2500 Suburban
  23. Replies
    16
    Views
    1,619

    I took the pics with my cellphone camera so it...

    I took the pics with my cellphone camera so it looks funny from the ass end.
  24. Replies
    16
    Views
    1,619

    PIC'S of the Ride

    My 1996 K2500 Suburban
  25. Replies
    6
    Views
    669

    Just another NEW guy

    Well ive been driving GMC's or CHEVY's sence i was 16 years old. Just saw the sight and thought i would join. Right now i drive my 1996 K2500 Suburban 6in lift 37in nitto tires on 17in rims. Full...
Results 1 to 25 of 25