GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: SoundZman

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    544

    oxygen sensor part #'s

    I hoping someone here has an answer to this question...

    Does anyone know why some manufactures, of o2 sensors, have the same part number for Upstream & Downstream sensors while others have two...
  2. Replies
    5
    Views
    5,873

    No the ones I picked up are not too bright at...

    No the ones I picked up are not too bright at all. I picked up a pack of 50 off Ebay, just incase I got a spark to do other locations I wanted them all to match. You'll also need to add a resister...
  3. Replies
    2
    Views
    393

    Well that would be the best option & the...

    Well that would be the best option & the cheapest. Although, $25 for the handle and about $60 paint products from Paintscratch.com isn't too bad either. But I like free...we'll see tomorrow.
  4. Replies
    2
    Views
    393

    03' driver door handle "play"

    The other day I noticed about 3/4" of slack in the driver door handle pull (exterior) before it hits the latch. I'm probably going to pull the panel off tomorrow but I was just wondering if anyone...
  5. Replies
    5
    Views
    5,873

    I did an LED conversion on mine last year and it...

    I did an LED conversion on mine last year and it wasn't really difficult, just time consuming. One thing I would suggest make sure to set/mark you needle calibration points, otherwise you'll have a...
  6. Well the Too Lean code didn't specify any...

    Well the Too Lean code didn't specify any specific o2 sensor position...I can't say how exactly the shop installed the cats & muffler but I can say I stopped by at one point and the down pipe was...
  7. If your concerned with carbon buildup, then Lucas...

    If your concerned with carbon buildup, then Lucas is not really what your looking for since it's claim to fame is a "top end lubricant".

    I've used SeaFoam for a couple years now with no problem....
  8. P0174 Bank 2 Too Lean - after new Cats & FlowMaster installed

    I stated getting a Catalysis Efficiency code on Bank 2 earlier this year. So knowing it was going to be costly, I decided to wait until a better time financially. Well, last week I dropped it off...
  9. Replies
    5
    Views
    821

    My mechanic suggested that I put it in neutral,...

    My mechanic suggested that I put it in neutral, rev it up to 2000-2500rpms then turn the steering wheel back and forth. However this procedure is to help isolate a noise possible coming from the...
  10. Replies
    6
    Views
    559

    That's good info. I've never actually tried that...

    That's good info. I've never actually tried that and I've driven through snow a number of times...thanks!
  11. Replies
    15
    Views
    2,793

    I would start with looking, possible replacing if...

    I would start with looking, possible replacing if it's been a good while, the serpentine belt, pulley & tensioner. I would never replace a belt without replacing the tensioner as they tend to wear...
  12. Replies
    9
    Views
    604

    Bilstein's seem the be the "go-to" brand lately. ...

    Bilstein's seem the be the "go-to" brand lately. I put them on my burb last year around this time and don't have any complaints.
  13. Replies
    2
    Views
    479

    Hey I'm not saying it can't get boring from time...

    Hey I'm not saying it can't get boring from time to time. I have over 3000 songs on my iPod and they can get boring as well. But this Podcast helps to break up those stale times.

    If your an...
  14. Thread: Shock Help

    by SoundZman
    Replies
    10
    Views
    1,148

    I put some Bilsteins on last year, no...

    I put some Bilsteins on last year, no complaints...but I've also seen a lot of supporters of Rancho but haven't personally used them.
  15. Replies
    6
    Views
    960

    Honestly it really depends on your budget. I...

    Honestly it really depends on your budget. I would personally anticipate dropping about $300-400 for a nice quality amp. But you can also find something closer to $200 that should cover what's...
  16. Replies
    6
    Views
    814

    Thanks for the info TERRYNY....but I can pretty...

    Thanks for the info TERRYNY....but I can pretty much tell you exactly why my bank 2 cat failed. Just before moving out of state I began getting a Knock Sensor code for bank 2, I reset the code but...
  17. Replies
    4
    Views
    1,109

    Well I took it in to my mechanic and he tested...

    Well I took it in to my mechanic and he tested the both high and low pressure sides. Said the low side was spot on but high side was running a little high but not maxed out, indicating there's a...
  18. Replies
    6
    Views
    814

    Unfortunately being in California, the smog laws...

    Unfortunately being in California, the smog laws are very strict and became even stricter a couple years ago. Therefore the cat's have to be C.A.R.B (California air resource board) approved and...
  19. Replies
    2
    Views
    479

    Check out this Podcast/radio show

    I've been listening to these guys for about a year now. It's call "The Under the Hood Show", they broadcast on FM but also provide a Podcast on iTunes of their shows.

    The Under the Hood Show!
    ...
  20. Replies
    6
    Views
    814

    Getting cat's replaced...

    is $250 per catalytic converter (out the door) a good price for this?

    Sounds pretty fair to me...
  21. Replies
    3
    Views
    648

    I would guess more then likely you have the...

    I would guess more then likely you have the famous Intermediate Shaft noise (Intermediate Shaft Steering Clunk Silverado - Car Questions, Answers, and Discussion).

    Start with replacing mine to...
  22. Replies
    2
    Views
    2,507

    As for the lights on the 4wd selector all...

    As for the lights on the 4wd selector all lighting up. Mine has done this a few time in the last 6-8 months. I hit all the button but usually nothing happens then after driving for a few minuets it...
  23. Like Klutch M said, your best bet is to do a...

    Like Klutch M said, your best bet is to do a ReadyLift, Rough Country ect. leveling kit.
  24. Replies
    6
    Views
    960

    Sounds like possible the factory amp died. I...

    Sounds like possible the factory amp died. I only say this b/c the headphone jack doesn't need amplified signal. Probably not worth replacing the factory amp if this is the case. Might as well go...
  25. sucks, but glad to hear a resolution to a problem...

    sucks, but glad to hear a resolution to a problem on here.
Results 1 to 25 of 106
Page 1 of 5 1 2 3 4