GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: inspectormatt

Page 1 of 2 1 2

Search: Search took 0.03 seconds.

  1. Replies
    8
    Views
    3,013

    An 84 would have the TH700R4 transmission. The...

    An 84 would have the TH700R4 transmission. The 4L60E is an electronic controlled transmission which I don't believe has the same solenoids as the 700R4. On the 84 maybe the chug or shutter is caused...
  2. Replies
    5
    Views
    1,678

    I had a cheap set on my 84 Suburban before, they...

    I had a cheap set on my 84 Suburban before, they didn't last too long maybe 2 years at the most. But I went through several differrent gaskets and found out that the copper ones worked the best for...
  3. Craftsman makes them too or used to anyways.

    Craftsman makes them too or used to anyways.
  4. Replies
    11
    Views
    1,082

    When the actuator is broke it will blow the fuse....

    When the actuator is broke it will blow the fuse. Replace the actuator and then the replace the fuse.
  5. Replies
    11
    Views
    1,082

    I don't know how often they burn out but the...

    I don't know how often they burn out but the replacement one I bought has a lifetime warrenty. A manual lock would be nice thou.
  6. Replies
    11
    Views
    1,082

    Even with a floor shift transfer case there is an...

    Even with a floor shift transfer case there is an actuator on the differential. It's kinda towards the passenger side on the top. I've had to replace mine and check the fuse block also. There will be...
  7. Replies
    10
    Views
    3,229

    Im not sure of the wheelbase, I think its over...

    Im not sure of the wheelbase, I think its over 122", but regular suburban 4dr body style. I would like to go with LT285/75R16 on stock rims, but that may be too much. I also have had 255/70R16 on the...
  8. Replies
    8
    Views
    6,502

    Engine must be running, transmission in park,...

    Engine must be running, transmission in park, vehicle level, and the fluid hot. If the engine is not running you won't get a correct reading.
  9. Replies
    8
    Views
    2,434

    Could be a problem with the control head itself....

    Could be a problem with the control head itself. The motor down by the gas pedel is the one that controls where the air flows (panel vent, defrost vent, heat vent), you can remove the motor and move...
  10. Replies
    10
    Views
    3,229

    I have had 265/75R16 on stock rims on my 1993...

    I have had 265/75R16 on stock rims on my 1993 Suburban K1500 with no problems rubbing. Also had 32x11.5x15 on aftermarket rims with no problems. and my Suburban has no lift kit in it.
  11. Replies
    15
    Views
    2,227

    I've had tires cause this problem before. The...

    I've had tires cause this problem before. The belts break in the tire causing a severe wobble, also called "death wobble". Only does it at a certain speed, I don't know why. To check if this is the...
  12. Replies
    8
    Views
    6,502

    5 quarts. Put in a gallon first then slowly add...

    5 quarts. Put in a gallon first then slowly add the last quart to top it off, it may take a little more or a little less. Just keep checking it till its full.
  13. Replies
    8
    Views
    3,013

    If its a 4L60E transmission it probably the TCC...

    If its a 4L60E transmission it probably the TCC solenoid is not operating properly. You'll notice the shudder at a steady speed. It goes away when you accelerate because the torque convertor...
  14. Replies
    65
    Views
    10,257

    O"Reilly Auto parts is where I got mine for 40....

    O"Reilly Auto parts is where I got mine for 40. NAPA quoted me 48.
  15. Replies
    65
    Views
    10,257

    Yes, ignition didnt make sense to me either since...

    Yes, ignition didnt make sense to me either since it ran perfect once it started. But the ignition control module also control the injector pulse. So it wouldn't idle or idle rough if it did, and...
  16. Replies
    8
    Views
    5,283

    When I replaced the oil pan in mine, not only did...

    When I replaced the oil pan in mine, not only did I raise the motor but I also lowered the front differential. Its not diffcult to do but its worth it. The pan came right out once I did this. I...
  17. Replies
    65
    Views
    10,257

    I just had problems with my 93 Suburban 350TBI...

    I just had problems with my 93 Suburban 350TBI not wanting to idle, but would run if you stepped on the gas, and then it got worse to the point it would not start. But you could start it with...
  18. Replies
    8
    Views
    5,283

    Rear main seal usually starts leaking, or valve...

    Rear main seal usually starts leaking, or valve cover gaskets, or oil pan gasket. I use Fel-Pro rubber gaskets for the valve covers and a Fel-Pro one piece gasket for the oil pan and they work real...
  19. Replies
    5
    Views
    4,756

    Yep, ignition control module was the problem....

    Yep, ignition control module was the problem. Replace it and its up and running again! Thanks for your help!!
  20. Replies
    5
    Views
    4,756

    So does the ignition module control the fuel flow...

    So does the ignition module control the fuel flow somehow? I'm not familiar with fuel injection. I can hear the fuel pump, does that make any difference?
  21. Check to see if power is coming to the control...

    Check to see if power is coming to the control head. If there is, then it has to be a bad or loose ground wire. If I remember correctly there is two wires that should have power going to the control...
  22. I don't know about pushing it from under, but I...

    I don't know about pushing it from under, but I certianly had to take the motor mount bolts out and lift the motor up to remove the oil pan from my 93 4WD Suburban. Maybe you can rent a engine lift?...
  23. Sounds almost exactly as the same problem I'm...

    Sounds almost exactly as the same problem I'm having with my 93. I haven't figured it out yet.
  24. Replies
    4
    Views
    644

    Hard to find, but a 14 bolt rear end out of a...

    Hard to find, but a 14 bolt rear end out of a LIGHT DUTY 3/4 ton will swap right in. It is even a 6 bolt wheel pattern so it matches the front end and you can use the same rims. Otherwise swap both...
  25. Replies
    2
    Views
    586

    I haven't put one of those in. But I have put...

    I haven't put one of those in. But I have put B&M's Shiftplus Electronic Shift Improver into my 93 Suburban that has the 4L60E tranny. It makes quite a difference in the stage 2 setting, stage 1...
Results 1 to 25 of 49
Page 1 of 2 1 2