Type: Posts; User: bazar01
Search: Search took 0.01 seconds.
Soak with a good penetrating oil and mark the hex head of the bolt adjuster before making any adjustments. You want to count how many turns you crank the adjuster so you can put it back the way it...
On my 2013, 5.3L, 4x4, I get about
17.5 avg city driving on M5., AFM OFF
18.5 avg city on D, AFM ON
19-20 avg high way at 75mph
16-17 avg city
18-19 avg high way at 75mph
I had the same issue starting my 2001 suburban. It takes about 3-4 tries in the AM before it fires up. I was losing fuel pressure when engine was off. Thought it was a regulator issue so I changed...
I don't think you need to replace it. Check the fuel pressure and if it shoots up to 55 psi and held, it's good.
On my 2001, fuel pressure only went up to 45psi and dropped to zero in 3 minutes. ...
When you connected the meter from the disconnected ground to the ground wire, did you set the meter to DC-amp and what was the amperage draw?
11-05-2013, 10:31 PM
Can you get somebody to follow your Burb while doing 30mph to look at how the rear tires look when it bounces that much? I think this is a tire issue.
I have not looked at my 01 suburban with barn doors. What does the pin look like? Can you use a slide hammer with a tooling to attach to the pin head?
The EBCM relay circuit is internal to the module. You have to pull the module and open it to access the printed circuit board where the relays are soldered. The solder joints have cracked and need...
Are you sure there is no shim between the side gear and housing that has fallen out of place and blocking the side gear female spline?
Do a search here and you will find it.
Here is the Youtube link too:
It has been 10k miles since the ABS repair and still no ABS faults on the dash.
I know how it feels to go 60 on a 65. I have been doing this for a while now but everybody is just passing me and giving me a strange look just to get 20 mpg on the average on a full size truck. ...
I really do not care about the exhaust note. It is when it changes from V4 to V8 when you feel the rpm jumps up because of the increased torque of the V8 it could be causing the torque converter to...
On my 2011, on "D" or M6, when you are going 35-45 mph, AFM kicks in and out and very annoying. So I just put it on M5 and it stays on V8.
But when going >65mph, you won't even notice when...
I don't have oil consumption or oil burning issues at all. I change my oil every 7500 miles and still on top mark.
My mpg seems right on line as advertized. For me I don't see any benefit to...
On my 2011, I get 20mpg on the highway on actual mileage and gas consumption based on full tank going 70 mph.
City, I just put it on M5 and get 18mpg going from 35-45 mph speed.
You think the...
08-20-2013, 11:14 AM
With that many miles, I will make sure I do not have any other issues with the engine before i spend $1500. You can probably get a used 100k mile engine for cheap and installed at about the same...
Good luck finding a good used one from the junkyard that will last.
Just crawl under your truck and fix it. You can drive it while it is out for repair, just make sure you cover the surface where...
Which one? The wheel sensors or the ABS computer?
The wheel sensors are easy.
The ABS computer develops cracks on the solder. It needed to be taken out from under the driver side frame rail. ...
Could be as simple as cleaning build up on wheel sensors or cracked solder joints on ABS computer.
Mine turned out to be cracked solder on the brain. Reflowing relay solder joints on the pcb...
My 2001 is the other way around. What is going on with GM?
My front calipers use TORX while the rears use HEX head. :grrrrrr:
Yes my truck has exterior key holes. That was exactly the same theory the cop said about the key hole as a common access to the cab. But we did not see any scratch marks on the key hole. Once they...
The banks are already taken cared of early this morning. Closed the accounts and opened a new one as advised by the bank.
The doors locked but I did not hear the horn with the fuse...
Drove the truck up to Atlanta Saturday PM and went to Brunswick bowling center and parked it with a 6 x 10 enclosed trailer from 3PM - 7PM and had some fun time with my children.
06-18-2013, 04:53 PM
Not sure how much you can raise the front but you need to watch the ball joints for binding.
Results 1 to 25 of 265