Type: Posts; User: Randy_H
Search: Search took 0.03 seconds.
10-19-2012, 11:30 AM
I know that's the main thing that caused my entire problem. I have never heard of such a thing.....on all of google there was only one mechanic that mentioned it. One mechanic even instructed to...
10-18-2012, 11:39 PM
very long story short.....
1. buy only GM replacement distributor (not the brand new aftermarket)
2. align distributor correctly (which I did)
3. remove both battery wires for 20...
10-16-2012, 03:45 PM
soooooooooo........I am left with 1 code P0340 (cam retard is at -45 and it will not move no matter what I do)
changed PCM (from junkyard...same result with original PCM)...
10-11-2012, 09:40 PM
Cranked it up and let it warm up today.....drove around the block a couple of times and it started missing again (I could feel it scan tool did not report it). No check engine light.
10-11-2012, 12:25 AM
Try this on for weird.......
I tested the temp sensor wire and could not find anything wring with it. So I decided to go change the new temp sensor in case new one was a lemon. Installed the new...
10-09-2012, 11:33 PM
I took the dash apart to see if the radio just had a loose connection and if it was a separate issue. I can't confirm that yet...so far the radio hasn't reset to 1:00.
Just for fun I cleared the...
10-09-2012, 10:56 AM
I removed both and confirmed that they are not corroded and are tight. Sorry I didn't mention that before.
10-08-2012, 11:11 PM
Installed new BWD temp sensor....idled OK
Test drive....misses horribly.
P0304 code gone (even after several test drives)
Initially it had these codes:
P0118 Engine Coolant Temperature...
10-08-2012, 07:49 PM
I just installed brand new BWD plug wires
I let it idle 5 minutes, then cut it off and cranked it a few times then backed out of the garage and drove to the end of the driveway.....where it...
10-08-2012, 03:09 PM
I will pick some up in a few and install them.
I have a snapon ethos scan tool on it....from what I have read (I am no expert) when you change the distributor these are the steps:
10-08-2012, 01:01 PM
PS: cam retart at 0
just thought I would add that info.
10-08-2012, 12:48 PM
I will try this in a few.....I didn't even think of that.
- - - Updated - - -
omni pro OE wires (don't know much about them took Oreilly's advice)
acdelco iridium (every chevy I have had...
10-08-2012, 12:14 AM
I have never posted for help on a forum before........but I am at the end of my rope.
Multiple random misfires on random cylinders under load.
I have installed new:
Cam Position Sensor
Long time chevy owner short time board member.
I live in Princeton, NC (about 30 miles southeast of Raleigh).
Results 1 to 14 of 14