GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: Brad Wissinger

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    1,299

    Sunds good. I'm checking with local dealers to...

    Sunds good. I'm checking with local dealers to try to get it. The last time I had the pads/calipers off, the cpistons moved pretty easy. Based on the excessive wear of the passenger side pad, I'm...
  2. Replies
    11
    Views
    1,299

    So I just checked the fluid and it wasn't...

    So I just checked the fluid and it wasn't blue...was black.


    On the passenger side, one of my pads looks like it's wearing pretty heavy, and my driver side caliper has a little play in it (side...
  3. Replies
    11
    Views
    1,299

    I haven't worked the brakes since I bought the...

    I haven't worked the brakes since I bought the truck two years ago. Where can I get the Trac II fluid? Are there any replacements for it, like Royal purple or Lucas?
  4. Replies
    11
    Views
    1,299

    Are the rotors being warped a possibility?

    Are the rotors being warped a possibility?
  5. Replies
    11
    Views
    1,299

    Hubs are from Napa ($129/ea), the first ones I...

    Hubs are from Napa ($129/ea), the first ones I got we're the cheap China junk. The big nut is properly torqued to 157 (+5/-0) ft/lbs. I don't use a lot of air tools. Was raised without them, so don't...
  6. Replies
    11
    Views
    1,299

    Bearing/Rotors Question

    Alright, go another issue I need some assistance with. I recently put on a 6" suspension lift running 35" Nitto Mud Grapplers. When I had the rims and tires off and everything all disconnected, I...
  7. Replies
    11
    Views
    1,420

    VA is for Lovers...and idiot drivers. That's why...

    VA is for Lovers...and idiot drivers. That's why in a couple months I'm gettin outta this state, and hope to never come back. If it's not avoiding pot holes (craters) on 64/264/564, it's avoiding...
  8. Replies
    1
    Views
    834

    IFS to Solid Axle Conversion

    Ok, new thing I'm looking into is a Solid Axle Swap. I can't seem to find any kits for a 1999 1/2 1500 4wd. Any body know anything about this? I'm just starting to do research about it, so I am...
  9. Replies
    9
    Views
    1,033

    Sorry about that. I did the lift myself. It was...

    Sorry about that. I did the lift myself. It was actually pretty easy too.
  10. Replies
    9
    Views
    1,033

    GOT THE LIFT AND TIRES DONE!!! Posting pictures...

    GOT THE LIFT AND TIRES DONE!!! Posting pictures to my profile now!
  11. Replies
    9
    Views
    1,033

    Oh you know it!! I took it out for the first time...

    Oh you know it!! I took it out for the first time tonight and cruised around for a bit. The exhaust sounds GREAT!! Not bad, considering I bought it on eBay for $190! Haven't noticed any real change...
  12. Replies
    9
    Views
    1,033

    Got my exhaust and intake in on...

    Got my exhaust and intake in on Thursday...couldn't help but install them. Truck sounds great now!! Got my CV axles in Saturday, waiting to install them until I install my lift, since I'll have to...
  13. Replies
    9
    Views
    1,033

    Upcoming upgrades!!

    So decided that all my upgrades will be ordered and shipped on Saturday!!! Pretty excited about it!

    Ordering my 6" NTD lift kit from Rough Country, 35" Nitto Mud Grapplers, dual (cat-back)...
  14. Replies
    13
    Views
    1,734

    Thanks everyone. I'll take a look shortly, and...

    Thanks everyone. I'll take a look shortly, and see what I can find!
  15. Replies
    13
    Views
    1,734

    Got the new bearings, installed them. Now the...

    Got the new bearings, installed them. Now the truck is back up and running. Got a new question though...steering feels loose now, I replaced outer tie rods a couple years ago, got the alignment done,...
  16. Replies
    13
    Views
    1,734

    Bought the hubs from "Aftermarket Auto Parts"...

    Bought the hubs from "Aftermarket Auto Parts" online. I knew the passenger hub was bad, but hadn't checked the drivers side. I checked them after I got the new hubs to see how bad (a comparison from...
  17. Replies
    13
    Views
    1,734

    Alright, so I got new bearings in (I ordered them...

    Alright, so I got new bearings in (I ordered them online) jacked up the truck, and checked the drivers side. It wasn't bad, but I swapped it anyways. This was the side that only had the stub of the...
  18. Replies
    9
    Views
    2,507

    Just came across a website (www.4wheelonline.com)...

    Just came across a website (www.4wheelonline.com) and I found Nitto Mud Grapplers for less than $300 per tire!! I'm thinking I'm going to go with those. Thanks for all the inputs guys.
  19. Replies
    9
    Views
    2,507

    Need input on new tires

    Going to be lifting my truck and running 35's. I was looking to get some input on tires. I'm going for the 'hum' you get on road and my off-roading here is basically mud, so I'm going for Mud...
  20. Replies
    11
    Views
    1,740

    Yea, I agree with changing gears, but I'll have...

    Yea, I agree with changing gears, but I'll have to wait a little bit. I appreciate the input from SouthEastBeast, but my truck has no warranty on anything. Well, I take that back, it has the "Old...
  21. Replies
    11
    Views
    1,740

    I'm good with keeping the torsion bars because...

    I'm good with keeping the torsion bars because that RCX lift keeps them tucked up. You get the ground clearance with them still on there, so I'm good with it. I had a 94 F150 that I ran the RCX 4"...
  22. Replies
    11
    Views
    1,740

    It's a nice looking kit, but that's just the...

    It's a nice looking kit, but that's just the front and baja isn't really the look I'm trying to get. thanks for the input though!
  23. Replies
    11
    Views
    1,740

    Thanks for the input. Do you know anything about...

    Thanks for the input. Do you know anything about a brand of tires called Hercules? I found 35" Hercules Trail Digger MTs for about $250 less than the Nitto's. I read reviews of them online, and the...
  24. Replies
    2
    Views
    528

    Oh man!! This is awesome!! Thanks very much for...

    Oh man!! This is awesome!! Thanks very much for the help! One more question for you though...Rough Country offers kicker braces and I looked at these. Are these recommended for part-time off-roading?...
  25. Replies
    2
    Views
    528

    Lift, rim & tire help...PLEASE!!

    Alright, hopefully I can get to the bottom of all these questions. First off, I got a 1999 1500 EXT Cab Z71 and my on-road to off-road driving is about 75% (on-road) to 25% (off-road) but I love the...
Results 1 to 25 of 42
Page 1 of 2 1 2