GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: k.daddy1

Page 1 of 5 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    5
    Views
    816

    Part number 69640, they cost a little under 300...

    Part number 69640, they cost a little under 300 smackers. Hope this helps!
  2. Replies
    5
    Views
    816

    I had the same problem with headers on my 85. The...

    I had the same problem with headers on my 85. The tech folks kept telling me they didn't make a shorty header. Went to Hedmans website and found a set for a 3/4 tone and 1 ton with a 350 motor....
  3. Thread: Idles issues

    by k.daddy1
    Replies
    3
    Views
    665

    I had a problem 2 yrs ago with the #2 injector...

    I had a problem 2 yrs ago with the #2 injector harness. It took the dealer a week to isolate the problem and 7 bills later it was fixed with a longer lead on #2. The symptoms are not the same this...
  4. Thread: Idles issues

    by k.daddy1
    Replies
    3
    Views
    665

    Idles issues

    I have an 05 Duramax 2500 with a 6 spd manual trans. I'm having an idle problem, think it may be a bad injector, but I want to hear what you have to say. It will only do it once the truck is warm,...
  5. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    After some severe cursing, scratching my head, I...

    After some severe cursing, scratching my head, I had a gentleman bring over his diagnostic program. He hooked his laptop up to the truck and discovered a big variation in the timing degrees. I don't...
  6. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    Here's where I'm at so far. I have replaced the...

    Here's where I'm at so far. I have replaced the Ignition module X2, coil, plugs, cap, button, distributor, ECT, TPS, done a noid test on the injectors. I have power to the injectors, power to the...
  7. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    Yes I am getting spark now.Two weeks ago, the...

    Yes I am getting spark now.Two weeks ago, the truck done the same thing, but it didn't have spark. I replaced the ignition module and the truck started and has run fine. I pulled the truck in to...
  8. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    Another question, Can the throttle position...

    Another question, Can the throttle position sensor or the coolant temperature sensor cause the fuel injectors not to spray?
  9. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    Mr. Shorty, If I understand this book right, I'll...

    Mr. Shorty, If I understand this book right, I'll have to crank the engine to put power to the fuel injector module to make the injectors pulse. Is that correct?
  10. Thread: No fuel

    by k.daddy1
    Replies
    13
    Views
    1,801

    No fuel

    I have a 98 silverado 1500 with a 5.7. The other day, the truck wouldn't start, found I didn't have no spark. Replaced the ignition module and all was fine till yesterday. The truck will crank over...
  11. From what you are describing, your block is going...

    From what you are describing, your block is going to need some work. If it has a definitive ring groove around the top of the cylinder bore, that block has not had any work done in many many miles....
  12. On the top right of your engine drivers side,...

    On the top right of your engine drivers side, close to the plastic cover is the fuel pressure regulator. It has a vaccuum line that connects to the regulator. With the engine off, pull the vaccuum...
  13. Thread: Slow draw

    by k.daddy1
    Replies
    8
    Views
    763

    I'll give it a shot tonight and post what I find....

    I'll give it a shot tonight and post what I find. I do have a fluke mulitmeter that measures amps down to the milliamp, and yes I do have 12 ft leads I use for working on aircraft. I just don't have...
  14. Thread: Slow draw

    by k.daddy1
    Replies
    8
    Views
    763

    Slow draw

    I've got a 90 Silverado that I have owned for years. I haven't drove the truck for about 2 months because the battery was dead. I knew the battery was getting old, so I replaced the battery thinking...
  15. Replies
    16
    Views
    4,997

    Pulling the injectors no!, but you will have to...

    Pulling the injectors no!, but you will have to disconnect the fuel supply. It will be towards the back of the R/H side intake. If your a DYI'r, you'll do fine. Just remember to clean both surfaces...
  16. Replies
    16
    Views
    4,997

    Is the truck running hot? If it's just blowing...

    Is the truck running hot? If it's just blowing white smoke and smells like anti-freeze, more than likely it's just an intake gasket.
  17. Replies
    17
    Views
    2,312

    If this truck has the newer generation 4.8 or 5.3...

    If this truck has the newer generation 4.8 or 5.3 motor, it does have a vaccuum line on the FPR. That is the quickest way to check if the diaphram has ruptured. The FPR is located on the right side...
  18. As far as your idling and shifting problems, your...

    As far as your idling and shifting problems, your first code show the TPS has low voltage. The throttle position sensor controls your idling and also controls the shift points through the computer to...
  19. Replies
    3
    Views
    1,679

    Thanks! Cigarrete lighter don't work, but will...

    Thanks! Cigarrete lighter don't work, but will check the fuse. Thanks Again
  20. Replies
    3
    Views
    1,679

    OBD II Power failure

    I have a 2000 chevy silverado that the SES light came on. I plugged my scanner up to it to retrieve the codes, but the scanner won't even power on. So just to check that my scanner didn't crap out, I...
  21. Replies
    12
    Views
    10,213

    You might want to check the fuel pressure...

    You might want to check the fuel pressure regulator. You may have good fuel pressure, but if the regulator isn't working the pressure is bleeding off back to the tank.
  22. Replies
    6
    Views
    3,816

    Brake bypass valve? Where is that located?

    Brake bypass valve? Where is that located?
  23. Replies
    6
    Views
    3,816

    I can tell it's new. It's shiney, clean and...

    I can tell it's new. It's shiney, clean and black. I can tell what parts were replaced, he even offered the receipts. Anyway, my thinking, "Aw It can't be that much wrong, it's just brakes!" Thought...
  24. Replies
    6
    Views
    3,816

    It has the hydro-boost brakes. How in the heck do...

    It has the hydro-boost brakes. How in the heck do you bleed the module? There is no bleeder screw.
  25. Replies
    6
    Views
    3,816

    Brake pedal kissing floor!

    I bought a 97 chevy 3500 with very low miles. The only problem when I bought it was the brakes were very spongy and the owner told me he had the master and slave boost cylinder replaced but didn't...
Results 1 to 25 of 112
Page 1 of 5 1 2 3 4