GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: BobEhud

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. no i couldn't agree ore where my shop is i see...

    no i couldn't agree ore where my shop is i see trucks with 12in plus lift..im sure they have a ton of money in them i really dont have a lift my extra height comes from having complete 1 ton running...
  2. lowered Suburban's whats the point in owning a Burban if it cant go over speed bumps

    Maybe its just me but i pulled in next to a slammed Burban and i could only shake my head.I work in this industry and never understood lowered trucks..? I mean whats the point!You want something like...
  3. Replies
    10
    Views
    3,248

    ck your fuel pressure regulator,that is supposed...

    ck your fuel pressure regulator,that is supposed keep pressure at the rail so it fires right up.Small round item should be on drivers side.Single vacuum hose coming out if you pull that hose and...
  4. right on. i was going to do that sorry been doing...

    right on. i was going to do that sorry been doing this so long..i just forget people don't know me.going to crimp it off with a brake hose line lock. while doing the timing.Trying to see what others...
  5. your trans produces less than 50 psi as long as...

    your trans produces less than 50 psi as long as its double wall hose you should be fine a great of trucks and cars use ATF for their fluid.
  6. Replies
    1
    Views
    305

    the calipers have to have bolts to mount the...

    the calipers have to have bolts to mount the caliper to the spindle.They may not be obvious the would not have a typical bolt head on them but a recessed Torx bit.
  7. A little advice on timing a not so typical 91' 454 1 ton Burban'

    Im going to have the timing reset on Chub's today and it doesn't have the wire you disconnect.This has been converted to an older 454 and has ceramic headers,Edelbrock intake,Barry Grant Street demon...
  8. Replies
    4
    Views
    1,000

    Do this next pull the control module out of the...

    Do this next pull the control module out of the dist.take the cap and rotor off should be right under the rotor have wires coming into to dist and wires going out held with some 8mm or 1/4 bolts.Buy...
  9. this could be so easy.check your firing order.

    this could be so easy.check your firing order.
  10. wow a 454 in a 1 ton.I have a put together 1 ton...

    wow a 454 in a 1 ton.I have a put together 1 ton Suburban,,(no GM never made one in 91') as the previous poster had said is everything has to be right to get the best mileage and even with you...
  11. Replies
    4
    Views
    823

    could also be in your front hub bearing...

    could also be in your front hub bearing assembly.Have the truck scanned and see what that tells you.If it is the bearing not a real high dollar fix.With GM's this is 80 percent of the time the case.
  12. Replies
    9
    Views
    1,182

    a great deal of trucks have the fuel sending unit...

    a great deal of trucks have the fuel sending unit as part of the fuel pump assembly,yours is older enough you may get by with just replacing the fuel level sensor.That 88' is injected..?If so drop...
  13. you are not getting a signal to the system.Get a...

    you are not getting a signal to the system.Get a set of Noid lights and crank the truck if they pulse..(which they shouldn't) id have to be there to figure it out.
    remember no matter how much crap...
  14. Replies
    2
    Views
    3,755

    well i have done a Crank sensor before on...

    well i have done a Crank sensor before on different GM trucks this is interesting.Where did you find that warning again..? okay sorry re read your postt is the truck at all now..?If nor do the cranks...
  15. Replies
    9
    Views
    2,488

    let me say this slowly...lol.. 4.11/4.09/4.10...

    let me say this slowly...lol..
    4.11/4.09/4.10 whatever they are run a 35" tire.Just got rid of a truck i loved...it had 4.11 Richmond's and i drove by the tach not the speedo.
    2300 rpm,road trips...
  16. Replies
    4
    Views
    1,041

    If you have a complete Compressor failure you...

    If you have a complete Compressor failure you dump tons of aluminum into the system,and 1K is cheap..most times i just replace the condenser as well.The tubes in R134a Condenser are so much smaller...
  17. Replies
    4
    Views
    1,041

    you will need to do the Receiver Drier at the...

    you will need to do the Receiver Drier at the same time you do the Compressor,without doing so you will not get any warranty from anywhere. The drier has a big dis-scant bag to absorb moisture and is...
  18. Replies
    15
    Views
    2,447

    Chevy makes nothing,Chrysler makes nothing,Ford...

    Chevy makes nothing,Chrysler makes nothing,Ford makes nothing,etc,etc.
    Good GM parts are Delphi,no master pro pumps.Listen dropping that tank is a bear.Most all the premium pumps come with a harness...
  19. hope like all hell your wrong on the pinon and...

    hope like all hell your wrong on the pinon and ring gear...he just spent almost 3 grand having both done..it feels more toward the middle of the truck..i never thought about trans fluid and reverse...
  20. When shifting into reverse at higher idle can feel and hear loud 'CLANK' drive makes

    And wouldn't you know this would start when im out with a bad neck injury and cant take it to my job ( i run shops) it only happens in reverse and im fighting all my instinct to look under it while...
  21. Replies
    15
    Views
    2,447

    Mr. D. one question do you run your Burban below...

    Mr. D. one question do you run your Burban below a quarter of a tank much..?If so please check fuel pressure first,i run shops and cannot count the number of fuel pumps i have had to replace in the...
  22. I had a 97' bought with 6 miles on it drove it...

    I had a 97' bought with 6 miles on it drove it for a looong time i do cars and i had the same issue,took it a place that does nothing but electrical and lets see they replaced the multifunction...
  23. Western Auto was always owned by Sears and Sears...

    Western Auto was always owned by Sears and Sears one day just pulled the plug on them they then were turned into PartsAmerica,which was just a RedWhite and Blue AZ..then Advanced did a hostile take...
  24. Yeap...i was afraid someone was going to say that...

    Yeap...i was afraid someone was going to say that im glad in sprung for the blue gaskets,you reuse them a few times..secondary fuel circuit on the BG mimic's the Holley so i will move to 85's and...
  25. Odd thing happens under full throttle=can heard almost like a backfire noise

    Okay this is not your everyday Burban.It's a 91' with a 98/99 454 but its been converted to carb.Now the guy had spent some money on the engine and then slapped a leaky,shot Q-jet on it .I replaced...
Results 1 to 25 of 56
Page 1 of 3 1 2 3