Type: Posts; User: Maxx
Search: Search took 0.00 seconds.
a club with a Sonny and Cher revival, But upon entering a saw...
05-19-2009, 08:46 PM
This sounds like a winner to me.
Gotta love a man who keeps an eye out for his members.
They look real good
Christopher Walken had run off with...
What's a carbandelator?
I didn't say that the Chinese would do a bad job, Just I don't want my $$ going there on a major purchase.
Yes I do shop at Wally World.
I also don't want to buy Mexican products as they have too...
You can't use an XM radio antenna as it is microwave satellite frequency tuned.
I used to have a Custom built by me VW Turbo diesel Rabbit that I had a cool pre-amped antenna that was factory. It...
Time to start checking where it was assembled BEFORE you buy.
I can live with my Canadian one but I'll be damned if I buy one that was assembled in Mexico or China.
Also AM and FM are vertically polarized.
Going to horizontal causes a big loss of signal plus makes it directional.
If any of you are from the Huntsville area I used to repair auto stereos...
It can't be anywhere near the same.
It is surrounded by the body ground.
Plus if you listen to AM then the ignition noise is going to be worse.
As the back glass says, ''If I wanted a Hummer I would have called your sister...lol...J/K
05-11-2009, 10:41 PM
I have repaired several wiper boards that only work when they want to.
Every time it was cracked solder joints on the PCB.
Always at the connector to the wire harness.
If you can solder try there...
I have hauled my Honda around. Mine will fit diagonally in the bed.
If you can't haul it that way I'd make sure my gate cables were in very good shape.
Seriously, I'd make a rear tire mount bracket...
I have a '96 Silverado 4x4 with 195k.
I had the leaking rear cover also. It is common up here in Michigan for the covers to rust pin holes in them.
I sandblasted mine looked it over...
Results 1 to 16 of 16