GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: Indyandy

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. The camper is just about all I pull. I haul more...

    The camper is just about all I pull. I haul more loads in the bed, (gravel, wood, ect.) but I would like to get to the point where I can take off and go camping on the weekends. After I replace the...
  2. weight distribution or spring helpers or both?

    Own a 2000 K2500 ext cab long bed 7.4L auto
    I was given a old 19' Holiday Rambler camper. Truck squats when it is hooked up. (Might need new rear shocks too?) I dont know what I need. Do I need a...
  3. Replies
    16
    Views
    872

    After all the problems I had, I decided to...

    After all the problems I had, I decided to replace the cap and rotor. Now the truck will start and run, but it has a bad miss. I am guessing a bad wire or I didn't get the cap down tight enough. Was...
  4. Replies
    16
    Views
    872

    I am beginning to wonder if there is a timing...

    I am beginning to wonder if there is a timing issue? I pulled the plug wire off the first plug on the Lh side, and cranked it over a few times. When I pulled the plug it was dry. If the injectors...
  5. Replies
    16
    Views
    872

    What is the best way to check that the injectors...

    What is the best way to check that the injectors are working without a noid light or removing the upper intake to get to an injector plug?
  6. Replies
    16
    Views
    872

    Yeah, did that too.

    Yeah, did that too.
  7. Replies
    16
    Views
    872

    Let me go back to the fuel pressure. I used a...

    Let me go back to the fuel pressure. I used a gauge to find 52 psi for fuel pressure. Also, I cannot get the truck to a local parts store to have codes read. They wont rent them either because," they...
  8. Replies
    16
    Views
    872

    Would a stuck EGR valve do this? - - - Updated...

    Would a stuck EGR valve do this?

    - - - Updated - - -

    Is there a way to check codes without a scanner? I dont have access to one.
  9. Replies
    16
    Views
    872

    Ok, update: I checked the oil level to see if it...

    Ok, update: I checked the oil level to see if it had fuel in it, it was ok. I removed the hose on the throttle body and sprayed starting fluid in it. Still would not start. I pulled the first plug on...
  10. Replies
    16
    Views
    872

    This is a Vortec fuel injection. Can the ignition...

    This is a Vortec fuel injection. Can the ignition module be tested?

    - - - Updated - - -

    Ok, I checked the schrader valve on the fi rail and had lots of fuel pressure. I changed the battery out...
  11. Replies
    16
    Views
    872

    Need help asap please!

    2000 K2500 4x4 ext cab a/t 454 cid
    Been driving the truck without any problems. I leave work, it starts right up as usual. Stopped to get bait for 5 minutes, came out and it would not start. It just...
  12. Replies
    0
    Views
    253

    Fuel line connectors

    So I finally got my fuel tank down so I can replace the fuel pump, of course the fuel connectors on the sender wont budge. I cant get them off (I broke my tool trying). I am so tired of fighting...
  13. Replies
    5
    Views
    534

    Best replacement fuel pump

    2000 K2500 4x4 7.4 L a/t
    After further review, I believe my fuel pump died. What is the best option to use to replace it? I dont hear it run when key is turned on and no pressure. What are the...
  14. Replies
    8
    Views
    589

    When I went out to leave it cranked over, but...

    When I went out to leave it cranked over, but would not start. After a while of sitting, it finally did start. It sounded like it was running on 4 cylinders and only ran about 10 seconds before it...
  15. Replies
    8
    Views
    589

    The battery is fine, I tested it. It is only a...

    The battery is fine, I tested it. It is only a year old. I can pull a plug and check for spark correct? Is there a port to check for fuel pressure? I thought maybe cap and rotor, but when I replaced...
  16. Replies
    8
    Views
    589

    Need help asap please

    2000 k2500 4x4 a/t 454 v8

    Truck has been running fine. Ran an errand and when I can out truck would not start. It turns over and tries but wont start. It started once, but kinda dieseled. Like it...
  17. Replies
    1
    Views
    374

    Several questions looking for help

    2000 Chevy K2500 4x4 454 A/T

    1) What is the proper way to check the trans fluid? I always seem to get a different result. I usually check it with engine warm, running, and in nuetral after running...
  18. Replies
    5
    Views
    1,048

    The only time I hear it is when I am driving...

    The only time I hear it is when I am driving about 25 to 40 mph. Hard to hear above that. It sounds like it is coming from under the truck. It is not localized to where you hear it at one side or the...
  19. Replies
    5
    Views
    1,048

    noise when driving ~ 2000 K2500 7.4L

    2000 K2500 7.4L

    Jez, I keep finding more things to fix. When will it end? Anyway, there is a noise under the truck when I am driving. I thought it was the rear brakes, but it doesn't go away when...
  20. No, spacers and bushing were the same. I finally...

    No, spacers and bushing were the same. I finally tightened and retorqued the sway bar clamps to get that done. Let the truck down and installed the nuts without the last washer. Tighten the nuts to...
  21. what is the secret to installing sway bar links?

    2000 K2500 7.4L
    I finally got the old ones off, but I cannot get enough bolt thread on the new ones to go on. The bolts are the same length. I loosened the sway bar brackets. The frame is jacked...
  22. Replies
    3
    Views
    737

    flushing the cooling system. Any advise?

    2000 K2500 7.4L
    Just replaced the intake gaskets, now I want to flush the cooling system and get rid of any left over Dexicool. How much coolant do I need? What flush do you recomend? Do I need to...
  23. Replies
    8
    Views
    1,041

    People say that I should not use the rubber seals...

    People say that I should not use the rubber seals for the lower intake. Instead use a 1/4 inch bead of red rtv. Any thoughts?

    - - - Updated - - -

    Will I need to reset the timing on this? I...
  24. Replies
    8
    Views
    1,041

    What is the best way to get the ac hoses out of...

    What is the best way to get the ac hoses out of the way? How do I clean the EGR?
  25. Replies
    8
    Views
    1,041

    What brand of gaskets do you recomend? Is there a...

    What brand of gaskets do you recomend? Is there a distributor gasket or seal? Do the valve covers have to come off? Any other gaskets needed?
Results 1 to 25 of 42
Page 1 of 2 1 2