GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: ippielb

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    31
    Views
    2,992

    I had put new Moog hubs on the truck less then...

    I had put new Moog hubs on the truck less then 45,000 km ago. I'd hope it's not a hub.

    Ground was cleaned when I changed the oil a week before.

    I will have to test the hub and check if its a...
  2. Replies
    31
    Views
    2,992

    Changed the front left wheel sensor, the old...

    Changed the front left wheel sensor, the old sensor was broken off in the hub. Got rid of the abs light. I have code c0226 now, and again c0225. When braking at 10km/h the abs kicks in.
  3. Replies
    10
    Views
    801

    The mechanical fan doesn't spin from no where, it...

    The mechanical fan doesn't spin from no where, it takes power from the engine to turn the fan. Putting an electric fan frees up resistance. Which gives more power. What do fans do? Move air, electric...
  4. Replies
    31
    Views
    2,992

    That's good to know, thank you, i didn't know...

    That's good to know, thank you, i didn't know that it had to exceed 8mph. I thought it only had to get any kind of reading. I guess i have to take the truck out of the shop for a little drive.
  5. Replies
    5
    Views
    386

    Look into PlastiDip.

    Look into PlastiDip.
  6. Replies
    31
    Views
    2,992

    Checked it before i bought the sensor, had about...

    Checked it before i bought the sensor, had about 6 abs codes come up, C0226, C0221, C0225, ect., then a bunch of U1000, U1016, U1041, U1096, U1064, and a B0026... So i had a lot to work with, i ended...
  7. Replies
    31
    Views
    2,992

    c0225 ABS Code cant figure it out

    2002 Chevrolet Silverado 1500 4x4 with tow package, had the abs light come up, it is a C0225, EFI Live says open rear abs sensor. I cannot for the life of me figure this code out. I have just went...
  8. Replies
    10
    Views
    801

    I bought a flexalite dual electric fan with...

    I bought a flexalite dual electric fan with variable speed, so it doesn't turn the fans on full blast if it's not too hot. I spent $500 on the full kit which included everything in the box, brackets...
  9. Replies
    0
    Views
    130

    What I've been Keeping Busy With

    I haven't been on here lately, i've been extremely busy with work, the farm, and i have started to get move commited to making youtube video's which takes a LOT of time especially when you film in 4k...
  10. How To Change Torsion Bar Crossmember Bushings

    http://youtu.be/CjqTCtRIe8M

    Made a video a while ago about how to change your torsion bar crossmember bushings but people never liked the music. So i remade the video without music, so if you ever...
  11. How To Change Torsion Bar Crossmember Bushings

    http://youtu.be/CjqTCtRIe8M

    Made a video a while ago about how to change your torsion bar crossmember bushings but people never liked the music. So i remade the video without music, so if you ever...
  12. Replies
    0
    Views
    310

    Racerback Cab Fairing Removal

    So i'm looking at buying another truck, this ones a silverado 3500hd duramax dually. Only problem is the truck has the cab fairings on it. and a visor, which is held down with screws. IT would be...
  13. Replies
    64
    Views
    88,088

    Sticky: sorry for long reply, i have pacesetter long...

    sorry for long reply, i have pacesetter long tubes on it.
  14. Replies
    2
    Views
    747

    your suburban has the torsion bar suspension, all...

    your suburban has the torsion bar suspension, all the 2-3" lift is are keys, simple to do if you have an unloading tool. basically a tie rod remover but machined to fit the torsion bar crossmember to...
  15. i actually had this happen to me not so long ago....

    i actually had this happen to me not so long ago. I had my doors locked, and while iwas at work i lost the keys somewhere. So i had to break into my truck and use my spare key. I went to ebay and...
  16. Replies
    3
    Views
    1,732

    I did actually get a new thrust washer from...

    I did actually get a new thrust washer from wrecker and put it in. Hasn't given me any problems.
  17. Replies
    41
    Views
    3,730

    just give the starter a whack with a hammer....

    just give the starter a whack with a hammer. there is a coil inside it that usually gets a short in it. Giving it a whack or two usually fixes it. But if it happens again, you know what to do.
  18. On my door it says 6400. I guess i will need to...

    On my door it says 6400. I guess i will need to take the truck loaded to a scale to see the weights on the different axles. I have a 2006 Duramax 2500hd as well, but i want to make sure i have a...
  19. Here's what i was adding, this is an over...

    Here's what i was adding, this is an over exaggeration on weights.

    Sled Deck - 500lbs
    Sled 1 Wet - 600lbs
    Sled 2 Wet - 650lbs
    Gear Wet- 200lbs
    Passengers - 350lbs
    Supplies - 200lbs

    Trailer...
  20. Increasing Vehicle GVWR ~ 2002 Silverado 1500

    I am wanting to increase my vehicles GVWR, it is a 2002 silverado 1500, with a 5.3l engine, 4.56 gears, air bag helper springs in rear, along with 6.5" lift springs. also have 35" 10 ply E-Rated...
  21. Gauges are only necessary if you are going to be...

    Gauges are only necessary if you are going to be driving the truck hard.

    DPF will give great benifits, but if you have any emmisions they will be sticky on it.

    Tuners, get a custom tune from...
  22. Tighten the torsion bar on the drivers side until...

    Tighten the torsion bar on the drivers side until the distance from the center of the hub cab to the bottom of the fender(straight up). Make both the sides match.
  23. How To: Change Torsion Bar Crossmember Bushings

    http://youtu.be/-cfexroJoP0
  24. Replies
    19
    Views
    4,170

    Debating on taking my dirtymax for a road trip to...

    Debating on taking my dirtymax for a road trip to red deer. But doubt i can get the time off work. We are so far behind at work on the roads in Regina i need to work as much overtime as i can. I love...
  25. Replies
    0
    Views
    3,513

    Lower Steering Column Bearing Replacement

    I have a steering knock and i was wondering how one goes to replace the lower steering column bearing. I thought that you could take the Intermediate steering shaft and then pull the bearing down...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4