GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: chevyracingss

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Silverado HD :: 2002 Chevrolet Silverado 1500HD

    Silverado HD :: 2002 Chevrolet Silverado 1500HD (2013-03-06 19:31:49)
  2. Replies
    9
    Views
    1,359

    Thanks for all the input so far guys, my ULTIMATE...

    Thanks for all the input so far guys, my ULTIMATE goal for fuel economy is between 20-22 MPG hwy, but please understand I know this is going to require ALOT OF UPGRADES, to include driving style as...
  3. Replies
    9
    Views
    1,359

    help for new silverado owner

    hey guys, i just purchased a 2002 1500HD, i heard that you can improve power and fuel economy by helping the the 6.0L breathe better. i was just wondering which CAI and exhaust combo you guys have...
  4. Needs trans swap help quick!!!!!!!!!!!!!!!!!!

    I have a 90 K1500 5-spd(HM-290) that the over/under shaft went out on. It seems spendy to get the shaft when i will be doing a motor swap in the very near future. I am planning on building a...
  5. GM Truck Club around Ft. Hood, TX?????????????????????????

    I was just wondering if their was truck club around the Ft. Hood area already or not. I do know there are a lot of different vehicle clubs and even some vehicle specific clubs (motorcycle,...
  6. 5.7 L Vortec L31 Torque Monster Build Suggestions.

    I will be getting a 96 Z71 in Feb. of 2012, been doing some research on the motor and it appears that Chevy set it up to tow from the factory. 250-350 HP at 4600 RPM and 430-450 lb-ft at 2800 RPM...
  7. Replies
    2
    Views
    601

    sounds like you may have forgotten to reattach a...

    sounds like you may have forgotten to reattach a ground.
  8. Replies
    9
    Views
    1,375

    yeah kinda, but no jets/fuel injectors. it is...

    yeah kinda, but no jets/fuel injectors. it is primarily just gaskets, and comes with new fuel pressure regulator.
  9. Replies
    4
    Views
    6,420

    I have heard of the chisel trick, some people...

    I have heard of the chisel trick, some people swear by it. I personally have never been able to make it work. As for the RTV, if you use it as "glue" and apply it in a thin cost to the gasket, I...
  10. Replies
    9
    Views
    1,056

    ok, so short of buying a completely different...

    ok, so short of buying a completely different truck, what can I do????
  11. Replies
    9
    Views
    1,375

    Also another suggestion is that if it sat for a...

    Also another suggestion is that if it sat for a while (during the summer I'm guessing) i would invest $30 in a Throttle Body Rebuild Kit and pas special attention to the Fuel Pressure Regulator.
  12. Replies
    9
    Views
    1,056

    Was Wondering if it was possible.

    I have a 90 K1500 350 5spd Getrag. I am wanting, and kinda needing a K2500. Now I know that i can go out and buy one, but where is the fun in that??? Plus, I can spend around $10,000 now for what...
  13. Replies
    4
    Views
    6,420

    Here is what I can tell ya, I believe the fan...

    Here is what I can tell ya, I believe the fan clutch nut is like 30mm or bigger. i do know that when i got a fan clutch tool kit from AutoZone, none of the tools fit. They were either too big or...
  14. Replies
    4
    Views
    775

    if the truck idles fine on a cold start,...

    if the truck idles fine on a cold start, theoretically speaking, your pressure should be decent. not perfect, or fine, but decent. usually bad fuel pressure would cause a cold start to sputter or...
  15. Replies
    1
    Views
    377

    If you have stock rims they are either 7 or 7.5...

    If you have stock rims they are either 7 or 7.5 in width. I don't believe (I may be wrong) that you can go wider than 8 or 8.5 at the max on 16in rims, even aftermarket. The only thing wider that I...
  16. Replies
    3
    Views
    474

    90 k1500 5.7l

    90 k1500 5.7l
  17. Replies
    2
    Views
    878

    Assuming it is the original engine, no there is...

    Assuming it is the original engine, no there is no crank sensor.
  18. Replies
    1
    Views
    999

    Try testing the ECT(Engine Coolant Temperature)...

    Try testing the ECT(Engine Coolant Temperature) sensor on the front of the intake manifold. Use a multimeter and check the resistence value of the sensor (not the lead) with the engine cold, halfway...
  19. Replies
    3
    Views
    474

    Need Help Deciding On Exhaust Mods.

    I have got a $500 budget approved by the wife to redo my trucks exhaust. I am definitely going with some sort of cat less (cat-delete) glasspack system. Here is where the problems lie. I have been...
  20. Appreciate the help so far. but got the fuel...

    Appreciate the help so far. but got the fuel problem fixed. I had to take the rubber boots off of the connectors for the ICM. That fixed the problem with the fuel. However, the truck is still not...
  21. Need Help and Quick!!! 90 Chevy Won't Start

    Hey Guys,

    I have a 1990 K1500 4WD 5-Spd. 5.7L TBI. The Truck Won't Start. It is not spraying fuel from the injectors. There is also no power at the injector connectors. I have tested...
  22. Replies
    1
    Views
    664

    Just an update. After the longest two weeks ever...

    Just an update. After the longest two weeks ever (more like 3 months) I finally got it fixed. The problem was that Autozone sold me the wrong clutch fork. I ended up replaceing it with an ACDelco...
  23. Replies
    1
    Views
    664

    90 K1500 clutch job

    Just replaced the clutch in 90 k1500 and now the clutch fork is binding. I had to get a new clutch fork from autozone ($50) because the old one was cracked severely at the pivot ball. the new...
  24. Replies
    9
    Views
    993

    sorry, should've done more looking before...

    sorry, should've done more looking before posting. I guess this is a perfect situation of opening mouth and removing all doubt.
  25. Replies
    2
    Views
    799

    Fixed the problem somewhat, the gauges move a lot...

    Fixed the problem somewhat, the gauges move a lot less now. There is a cab ground next to the battery that grounds to the "inner fender." I cleaned that up, cleaned up the engine block ground, the...
Results 1 to 25 of 28
Page 1 of 2 1 2