GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: kinglt1

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. From my understanding codes can cross......

    From my understanding codes can cross... especially on emission related dtc's. My truck has thrown 2 different evap codes for just the gas cap lol. Although I never get the po446 since I cleaned the...
  2. Replies
    67
    Views
    95,963

    Sticky: Just wanted to give a little update... I replaced...

    Just wanted to give a little update... I replaced my intermediate shaft with gm's updated part a year ago. So far it is still working like new 15k mi later!
  3. Replies
    15
    Views
    3,841

    Fyi those corsa tips are polished stainless not...

    Fyi those corsa tips are polished stainless not chrome.. big difference. On my 92 gmc sierra I had magnaflow stainless tips that lasted long as I owned the truck.
  4. I change oil all the time lol... My point is if...

    I change oil all the time lol... My point is if you change your oil sooner than the computer says your just wasting oil. Again it reads the breakdown of the oil via driving habits. My truck usually...
  5. x2 agreed! change it when the computer tells you...

    x2 agreed! change it when the computer tells you to. Gm won many awards with thier oil life monitor sensor. It actually reads oil break down via your driving habits.
  6. Replies
    15
    Views
    3,841

    stainless tips ftw! On a side note after you...

    stainless tips ftw! On a side note after you clean the tips, put a coat of wax on them... helps protect the surface and makes cleaning them alot easier the next time around.
  7. Replies
    31
    Views
    15,898

    I have had great luck with valvoline maxlife over...

    I have had great luck with valvoline maxlife over the years.

    ---------- Post added at 01:14 PM ---------- Previous post was at 01:11 PM ----------



    Seen in your sig you have a throttle body...
  8. if thats not the problem check the waterpump......

    if thats not the problem check the waterpump... the pump has a small weep hole in the side facing the block.
  9. if the truck runs rough at lower rpm but clears...

    if the truck runs rough at lower rpm but clears up when you floor it, usually thats an o2 sensor. Go to your local parts store and get the ses code pulled...
  10. Is it the same p0446 code popping up? Sometime...

    Is it the same p0446 code popping up? Sometime after I fixed my vent valve, a code started popping up again and it was p0449. Wich is a small leak detected... wich is usually the gas cap seal. I had...
  11. Replies
    8
    Views
    3,995

    http://www.grizzlygrip.com/boats.asp for the do...

    http://www.grizzlygrip.com/boats.asp for the do it your selfer, or go to a rhino liner dealer. Make sure you do some research because not every shop does a good job installing the bedliner coating....
  12. Correct use compressed air only, no wd-40 lol...

    Correct use compressed air only, no wd-40 lol...
  13. Guys did you read the wrote up in my first post?...

    Guys did you read the wrote up in my first post? po446 means your vent valve is clogged, it has nothing to do with a leak or gas cap issue. If your gas cap is leaking or there is a leak in the...
  14. Replies
    67
    Views
    95,963

    Sticky: No need to apologize, thats what this site is...

    No need to apologize, thats what this site is for! I never herd of the updated part having the same issues until now... I guess that I can just hope for the new part lasts awhile, it's been good so...
  15. Replies
    1
    Views
    4,362

    for my 03 I had to remove the (2) caliper...

    for my 03 I had to remove the (2) caliper assembly bolts and the (2) t-55 caliper pin/bolts and pull the caliper into 2 pieces to remove the pads. The pads are notched and slide into the caliper...
  16. Replies
    67
    Views
    95,963

    Sticky: Do you have any experience using the updated...

    Do you have any experience using the updated part? What makes it a piece of ****? Mine has worked flawlessly... You need to explain your claims because just calling something a piece of **** seems to...
  17. Replies
    67
    Views
    95,963

    Sticky: It's an updated design from the original.

    It's an updated design from the original.
  18. Replies
    23
    Views
    4,703

    Your rhino liner must of been screwed up upon...

    Your rhino liner must of been screwed up upon install. I have the rhino liner on my 03' silverado w/ 140,000 mi and it looks brand new still!!!
  19. Thread: Gas mileage

    by kinglt1
    Replies
    26
    Views
    4,541

    my 03 silverado(2wd) runs 14.9-15.0 in the...

    my 03 silverado(2wd) runs 14.9-15.0 in the quarter with just an airaid intake! I guarantee it will drag your 00 f150 down the road!!!!:lol:Oh and it gets 17mpg city 20hwy...
  20. Replies
    67
    Views
    95,963

    Sticky: I replaced my steering shaft today. Ordered the...

    I replaced my steering shaft today. Ordered the part fom gm part irect, it was realatively an easy fix. It requires removing (1)11mm lower shaft bolt, (1)15mm middle shaft bolt, (1) 15mm top shaft...
  21. X2 Agreed!

    X2 Agreed!
  22. This fix is for code p0446, not p0440 or p0449!...

    This fix is for code p0446, not p0440 or p0449! You have a different problem!
  23. Replies
    14
    Views
    34,604

    Here's a write up I did awhile back on this! ...

    Here's a write up I did awhile back on this!

    http://www.gmtruckclub.com/forum/showthread.php?t=18964
  24. Back to the top!

    Back to the top!
  25. 03 silverado 5.3 intermittent noise at 40mph!

    Hi there! I am experiencing this audible whining noise when cruising at 40mph. Its especially noticeable on decel, but also comes in and out as the tranny downshifts. Also when goin over bumps at 40...
Results 1 to 25 of 44
Page 1 of 2 1 2