GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: carp

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    1,250

    bump.....same problem

    bump.....same problem
  2. Replies
    15
    Views
    2,963

    Just bought one on ebay...

    Just bought one on ebay...
  3. Replies
    15
    Views
    2,963

    That's what I wanted to do but I can't find these...

    That's what I wanted to do but I can't find these motors!
  4. Replies
    15
    Views
    2,963

    Im just assuming that some of my motors went bad....

    Im just assuming that some of my motors went bad. Mine look differrent than the ones on ebay for the '03 & up problem. My motors are small metal cased ones with 4 metal pins sticking out of the...
  5. Replies
    15
    Views
    2,963

    Everything checked out. The oil, gas and speed...

    Everything checked out. The oil, gas and speed gauges act up. The volts and temp are fine. If you flick the needles individualy, the speed, oil & gas needles will move very, very freely......oil &...
  6. Replies
    15
    Views
    2,963

    Could it be the sensor wheel itself inside the...

    Could it be the sensor wheel itself inside the tailshaft housing?....the one that the vss reads??
  7. Replies
    15
    Views
    2,963

    A ground problem? Why no cruise control all of a...

    A ground problem? Why no cruise control all of a sudden? If I plug in my scan tool that reads live data, I am getting a vehicle speed signal.....where is that coming from?.....the vss right?.... ...
  8. Replies
    15
    Views
    2,963

    Does this van actually have rear ABS? There are...

    Does this van actually have rear ABS? There are no rear wheel sensors or any sensors on the rearend housing but the ABS code is showing a difference in wheel speed from front to rear. ...
  9. Replies
    15
    Views
    2,963

    Its a 1998 GMC Savana 1500, 5.7 with 4L60E. Just...

    Its a 1998 GMC Savana 1500, 5.7 with 4L60E. Just replaced the only "speed sensor" in the trans tailshaft.....IT DID NOTHING. I thought it would at least turn out my rear anti-lock light. ANY...
  10. Replies
    2
    Views
    1,076

    Dealer item....called "Jounce Bumpers"

    Dealer item....called "Jounce Bumpers"
  11. Replies
    15
    Views
    2,963

    Speedo stuck at zero or buried past 100

    What causes the speedo to act up all of a sudden? If I pull out and stay under say, 25mph, it stays on zero......once it comes off zero, it reads way high and will eventually go past 100 and stay...
  12. Replies
    2
    Views
    1,076

    Rear auxilary spring / bump stop

    Anyone know where to buy these rubber bump stops / auxilary springs? They just snap into the round retainer disc mounted to the frame in the rear. I can't seem to find them at any auto parts stores.
  13. Figured it out......removed the box, placed it in...

    Figured it out......removed the box, placed it in a vice and it threads off....just tapped it with a punch and hammer.
  14. Steering box input shaft seal replacement.....PLEASE HELP!!!!

    How do you remove the large disc with 3 notches that the steering shaft protective sleeve snaps on too? Is it threaded in or pressed in? Special tool needed? This need to come off to access the...
  15. Replies
    0
    Views
    896

    For Sale (4) 18" 6 x 5.5 Chrome wheels

    These were on my 1997 Yukon. Sold the truck. The tires are junk. Some pitting on the backside but they clean up well. I believe they are 8.5" wide. I ran 285/60-18 tires on them. $650...
  16. Replies
    0
    Views
    1,073

    5 lug to 6 lug axle swap

    I purchased a 1998 gmc savana 1500 explorer conversion van. I want to swap out the axles to convert to 6 lug to use the wheels that I already have. Has anyone done this? Will...
  17. Thread: Old gas

    by carp
    Replies
    0
    Views
    708

    Old gas

    I'm buying a 1997 Savana that has been sitting for 3 years. It doesn't start according to the current owner (he stated that it needs a pcm). I need to know what terminals that I can jump to keep...
Results 1 to 17 of 17