GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: Bigg Ron

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    2,389
    Views
    183,043

    New Exterior Door Handle, Alternator, Belt, Idler...

    New Exterior Door Handle, Alternator, Belt, Idler and Tensioner. Oil Change With Penzoil Hi Milage and Fram Filter, Replace Blower Switch.

    184K and Still Going Strong.
  2. Replies
    7
    Views
    3,944

    It sounds like you fan clutch may need replacing....

    It sounds like you fan clutch may need replacing. Best to put the gagues on and see whats happening in the A/C system.
  3. Thread: 1997 chevy

    by Bigg Ron
    Replies
    2
    Views
    578

    I would go with the 4L80. its a strong tranny....

    I would go with the 4L80. its a strong tranny. but may only bolt up to a big block
  4. The Map sensor should be mounted on the intake...

    The Map sensor should be mounted on the intake manifold.
  5. Replies
    6
    Views
    555

    Welcome to the Club!

    Welcome to the Club!
  6. Welcome to the Club! And yes on that...

    Welcome to the Club!
    And yes on that transcooler, did many a rebuild due to a overheated trans!

    ---------- Post added at 07:26 AM ---------- Previous post was at 07:24 AM ----------

    Welcome to...
  7. Replies
    19
    Views
    2,948

    Welcome to the Club Travis!

    Welcome to the Club Travis!
  8. Replies
    14
    Views
    2,448

    Welcome to the club! Nice truck, so what do you...

    Welcome to the club!
    Nice truck, so what do you do in the USAF?
    I was a refueler "POL"
  9. Welcome to the Club! The outside temperature...

    Welcome to the Club!

    The outside temperature display lights going off in ths start position sounds normal, it could be related to the light switch or the BCM.
  10. Replies
    2
    Views
    609

    Welcome to the Club! I would start by check...

    Welcome to the Club!

    I would start by check the grounds, next would be the light switch.
  11. Replies
    4
    Views
    985

    Welcome to the club! Maybe easiest to drill out...

    Welcome to the club!
    Maybe easiest to drill out the rivets. as for the socket, it may be broken and under the truck, or never installed. You can get a plug that will plug into the existing harness,...
  12. Welcome to the club! Have you checked the crank...

    Welcome to the club!
    Have you checked the crank sensor?
  13. Replies
    7
    Views
    748

    Welcome to the club James!

    Welcome to the club James!
  14. Welcome to the club Tim, The door jam switch is...

    Welcome to the club Tim,
    The door jam switch is located on the A post when you open the door, it is a button that pops out.
  15. Replies
    6
    Views
    519

    Welcome to the club Nick!

    Welcome to the club Nick!
  16. Replies
    12
    Views
    874

    Welcome to the club!

    Welcome to the club!
  17. Replies
    15
    Views
    13,998

    Look in the duct work behind the glove box.

    Look in the duct work behind the glove box.
  18. Replies
    16
    Views
    1,220

    Welcome to the Club!

    Welcome to the Club!
  19. Replies
    7
    Views
    1,318

    Welcome to the Club!! Check the pressure releif...

    Welcome to the Club!!
    Check the pressure releif valve, it may be blleding your pressure offf and the pump amy need to run before you have pressure.
  20. Replies
    4
    Views
    1,435

    Is it slipping or just wont shift, sounds to me...

    Is it slipping or just wont shift, sounds to me like either the piston selas may be dried and hard and after it warms up it shifts or you could have a govenor issue, or clutch material has flaked off...
  21. Replies
    8
    Views
    773

    Welcome to the club!

    Welcome to the club!
  22. Replies
    4
    Views
    461

    I replaced mine with lines from Autozone, I have...

    I replaced mine with lines from Autozone, I have read that GM lines are best, I'd rather pay less and change more often.
  23. Replies
    2
    Views
    689

    Might check Autozone, they do have wiring...

    Might check Autozone, they do have wiring diagrams.
    www.autozone.com
  24. Welcome to the club!

    Welcome to the club!
  25. Replies
    7
    Views
    577

    Welcome to the club!

    Welcome to the club!
Results 1 to 25 of 167
Page 1 of 7 1 2 3 4