GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER

Search:

Type: Posts; User: black07sierra

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Audio T h a n k s

    T h a n k s
  2. Audio 2007 NBS radio swap keeping all factory options

    Putting a double din pioneer into my 07 sierra. Truck is a non Bose with onstar, satellite and steering wheel controls. Radio has built in Bluetooth. Are their any adaptors out there that will retain...
  3. Replies
    1
    Views
    549

    2007 nbs sierra parking brake issue

    Wife's brother used truck the other day and pushed emergency brake pedal so hard it went completely to floor. All cable are alright. Took drums off and cables still locked into springs. I watches...
  4. Replies
    9
    Views
    1,750

    Ended up being preignition caused by the e3 spark...

    Ended up being preignition caused by the e3 spark plugs. Put my iridiums back in and problem went away.
  5. Replies
    9
    Views
    1,750

    Well I had it in for a free service that included...

    Well I had it in for a free service that included fuel filter change. Oh well. It doesn't have one so I guess they didn't change it.
  6. Replies
    9
    Views
    1,750

    No check engine lights. No stored codes. Nothing.

    No check engine lights. No stored codes. Nothing.
  7. Replies
    9
    Views
    1,750

    106k on truck. Replaced plugs about 6k ago. Fuel...

    106k on truck. Replaced plugs about 6k ago. Fuel pressure checks in between 42-45 psi at the rail. Wires all within spec. Fuel filter changed about 15k ago. It's weird. Won't do it a for a couple...
  8. Replies
    9
    Views
    1,750

    07 nbs sierra 1500 miss at idle

    Truck started this a couple weeks ago. It has the 5.3 in it. No codes or anything. When sitting in park or drive I can feel the engine miss or stumble every now and then.
  9. Replies
    9
    Views
    2,060

    GM did repair and it's out of warranty now. Gonna...

    GM did repair and it's out of warranty now. Gonna replace the sensor tomorrow. The gauge dropped to 0 psi for about 20 miles yesterday and then back to 80.
  10. Replies
    9
    Views
    2,060

    Engine was pulled and new pistons and rings were...

    Engine was pulled and new pistons and rings were installed 12000 miles ago. Still burns oil but GM said its within specs. Thats another story. Oil changed regularly. I'm gonna change oil pressure...
  11. Replies
    9
    Views
    2,060

    I was thinking oil pressure switch too. It's only...

    I was thinking oil pressure switch too. It's only a $40 part. Hopefully someone that has access to the tsb's can look to see if this was brought up. In case anyone asks my engine has already had the...
  12. Replies
    9
    Views
    2,060

    Pressure. Oil pressure gauge pegging out at 80...

    Pressure. Oil pressure gauge pegging out at 80 psi every now and then.
  13. Replies
    9
    Views
    2,060

    Oil pressure high

    07 NBS Sierra 5.3. Ck engine light came on. Says oil pressure level high. Unsafe level. Anyone else ever run into this??
  14. Mode actuator is answer. Default mode is defrost...

    Mode actuator is answer. Default mode is defrost so you can drive it in winter if it fails.
  15. Ac starts blowing out defrost on its own

    2007 NBS Sierra. Has the auto climate control. I'll be driving down the road and it switches from vent to defrost and I can't get it to switch back unless I stop and turn truck off. I guess it resets...
  16. Bought another control module on eBay. Gonna try...

    Bought another control module on eBay. Gonna try it. Hopefully that is the problem.
  17. Only does it in auto ac mode. Still shows vents...

    Only does it in auto ac mode. Still shows vents after it switches to defrost. I can't change it back manually. I have to shut off the truck and when I turn it back on it works fine until it decides...
  18. Anyone else ever run into this. I have noticed it...

    Anyone else ever run into this. I have noticed it only does this on ac. Blowing in fresh air or heat it never does it. Only when ac is on.
  19. Replies
    11
    Views
    4,215

    Figured it out. Junkyard gave me an np246 out of...

    Figured it out. Junkyard gave me an np246 out of a truck with a 4l80e with 32 spline input shaft. Truck has a 4l60 with 27 spline output shaft. Same transfer case with different inputs.
  20. Replies
    11
    Views
    4,215

    Pulled the transfer case out and out it back in....

    Pulled the transfer case out and out it back in. It came out of an 06 Sierra 1500. With everything off ground I can put it in neutral and turn front and rear wheels just fine. If I put it in 4h or l...
  21. Replies
    11
    Views
    4,215

    It came from a junkyard. I took the encoder motor...

    It came from a junkyard. I took the encoder motor off and tried turning the shift shaft with a wrench and it starts clicking when I move it either way like its trying to lock into gear but can't or...
  22. Replies
    11
    Views
    4,215

    Still stuck in neutral. I can't think of anything...

    Still stuck in neutral. I can't think of anything else. Tried a new selector. Tried a new encoder but still stuck in neutral.
  23. Replies
    11
    Views
    4,215

    When you say change selector I'm assuming you...

    When you say change selector I'm assuming you mean try to change it from 2wd to 4h or 4l. I've done all that and I can hear the encoder moving the shaft and hear it changing gears but it is still...
  24. Replies
    11
    Views
    4,215

    2004 silverado stuck in neutral

    04 Silverado 4x4 transfer case stuck on neutral.

    Just replaced the transfer case. The original one locked up while driving. I got a new one and put it in but it is stuck in neutral. I can hear...
  25. Truck is out of warranty. Powertrain only. I'll...

    Truck is out of warranty. Powertrain only. I'll be happy if my dealer ever comes up with a way to fix the oil burning issue. They've done everything other than replace the engine and it still burns...
Results 1 to 25 of 26
Page 1 of 2 1 2