GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2
  1. #1

    Default 350 engine with 5 speed

    i have a 79 chevy truck with a 350 and a 14 bolt rear end i need a 5 speed trany with a t-case used any ideas??

  2. #2

    Default

    The tranny you want is the NV4500. It was used in 3/4 and 1 tons starting in 1988. I have seen a few 1/2 tons with this tranny but most have a light duty 5 speed you want to avoid. Just look for a 5 speed with a granny low 1st gear, no low first gear, skip it. The strongest transfercase would be a NP205 with a passenger side drop,but finding one that would bolt to a NV4500 without using expensive adapters would be almost impossible. They where only used in 1988-91 1 ton crewcabs. There's not much of a chance finding one in a salvage yard. I would look for a NV/NP 241 passenger side drop transfercase from a 1988-91 Suburban or Blazer. You will have to swap the input gear from 27 spline to 32 spline, but its a easy swap and the gears are available from Advance Adapters or Novak.

    97 Chevrolet Suburban K1500 5.7L
    78 GMC High Sierra K1500
    Fat, drunk, and stupid is no way to go thru life.

Similar Threads

  1. no high speed engine rpm??????
    By DoubleDD in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 13
    Last Post: 02-09-2012, 11:47 PM
  2. 01 k3500 8.1 6 speed manual engine stall
    By plowguy in forum Chevy C/K Truck Forum
    Replies: 1
    Last Post: 01-06-2012, 01:58 PM
  3. Wanted to Buy Need an Engine speed sensor for 6.2/6.5L
    By Joeairforce in forum General Classifieds
    Replies: 0
    Last Post: 01-03-2012, 08:24 AM
  4. Engine rough at ilde or cruising speed
    By MightyMax in forum General Chevy & GM Tech Questions
    Replies: 93
    Last Post: 09-17-2010, 10:13 PM
  5. engine sputters and pops at highway speed
    By gmc4life in forum GM Powertrain
    Replies: 7
    Last Post: 08-14-2007, 10:42 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •