Results 1 to 4 of 4
01-02-2008, 05:48 PM #1
Removing the front rotors on a 1991 4x4 Burb
I didn't do any prep reading before attempting the job.
I'm used to cars where you pull off the brake caliper and the rotor should just slide off. I guess I was a bit surprised when I got a good look at my Suburban setup. Looking at my Chilton's guide I think I need some sort of hub bearing tool?
Can I get this from the dealership or Schucks? A direct link to it would be great.
To be honest, the rotors look pretty good, but I should probably have them turned anyway? For now, I just installed the new pads to get rid of the wear sensor from squeaking.
01-02-2008, 07:25 PM #2
I never have rotors turned or replaced unless there is a pulsation in the pedal.
As far as the tool goes, do you mean the socket for the axel nut? Or something else?
Technology is great, when it Works,
And one Big Pain in the Ass When it Doesn’t.
Detroit Iron Rules, All the Rest are Just Toys.
94 GMC Burban, 5.7L (350), 4X4, Auto
86 GMC Burban, 350, 2 WD, Auto
79 GMC pickup plow truck, 400, Full time 4X4, Auto
86 Pontiac Fiero SE, 2.8L, Auto, only mid engine American car
See a Pattern yet?
15 year GM assembly line worker.
01-07-2008, 10:59 AM #3
01-07-2008, 08:39 PM #4
there is a hub nut tool they go for $10 at most auto stores.........mikeMichael Collins
1993 4X4 Suburban
many other toys as well
By Gryphon in forum General Chevy & GM Tech QuestionsReplies: 0Last: 02-28-2010, 11:09 PM
By scgamer_99 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last: 03-18-2009, 07:51 PM
By G.A. Heath in forum Photo & Video GalleryReplies: 3Last: 03-07-2009, 11:27 AM
By bigL in forum IA - Iowa Chevy Truck NutsReplies: 2Last: 01-01-2009, 11:01 AM
Tags for this Thread