GM Truck Club
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4
  1. #1

    Default 1995 - lost my AC and my defrost/floor adjuster at the same time

    could this be related to a faulty dash unit. Are these functions electrically controlled or vacuum actuated?

  2. #2


    I bet this is the issue....

    the gears break teeth and fail to work.

    the one you need to replace it the easiest to repair. it is right behind left side of the glove box. you can remove the glove box and see if the motor has a good connection or is just spinning and not changing the air direction. this is the same motor as the hot/ cold temp door and the fresh or recycle door and the same unit in the back air handler. goto a junk yard and get a replacement. if the issue is fixed eather get a new part or leave that one in untill it dies. i got one year out of the last one i swapped....mike
    Michael Collins
    1993 4X4 Suburban
    many other toys as well

  3. #3


    would I hear that motor turning if it did have missing teeth? I dont here anything at all when I turn the control knob.
    242K and still going strong!

  4. #4


    if enouh teeth are gone you almost can not hear the motor. you might have lost the switch. if you got a volt meter see if the door motor is getting power if so bad motor if not bad switch....mike

Similar Threads

  1. W/T floor mats for the plastic floor?
    By daweinah in forum Chevy Truck Accessories
    Replies: 3
    Last: 10-30-2009, 08:56 AM
  2. Defrost CFM
    By Six point in forum General Chevy & GM Tech Questions
    Replies: 2
    Last: 10-20-2009, 10:19 PM
  3. Can you add rear defrost?
    By Tdaz250 in forum Audio, Video & Gadget Tech
    Replies: 19
    Last: 09-29-2009, 02:42 PM
  4. 2nd time wheelin, 1st time stuck! pics!!
    By kawasaki_kid in forum Photo & Video Gallery
    Replies: 12
    Last: 05-08-2009, 10:46 AM
  5. Long Time Driver, first time owner
    By Tryptophan in forum Member Introductions
    Replies: 1
    Last: 06-22-2007, 07:43 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts