Results 1 to 6 of 6
Thread: Shiftn probs
11-09-2012, 09:03 PM #1
- Join Date
- Nov 2012
I have a 99 model tahoe and since ive had it it has a lil hesitation when i give it gas so i finally lookd into and my ENG-I fuse was blown so i replaced it and it made it run perfect but now when im riden down the road and floor it it dont wana shift right like its slippn a lil then itl finally go but if you jus drive it right everything works fine! But if i pull the fuse out n floor it itl shift like its suppose to! The tranny in it now is not old so maybe something didnt get hooked back up right? Any help will greatly be appreciated thanks
11-09-2012, 10:00 PM #2
In my 96 if you floor it the truck stays in a lower gear until it hits 4,000 rpm then it shifts. I've never felt any kind of slipping tho. My truck has about 197,300+ miles on it with a factory tranny. It isn't too hard to check the connections to the tranny, they are all on the drivers side pretty much just inspect the wires and see if everything is plugged in. Most likely there isn't a real issue just the ECU deciding when it is best to shift. Based on what you said in your other thread the original owner may have a tune on the truck which would change shift points especially if he spent the money to put bags on it and relocate the fuel tank.
1996 Chevy Tahoe LT 5.7L V8 4X4 202,000+ miles. Built proudly at Janesville Assembly in Janesville, Wisconsin
Basic mods: Lights all over, bunch of electrical work, and a couple cooling mods.
Check out my other mods in My Garage: http://www.gmtruckclub.com/forum/sho...t-Tahoe-4-Door
11-10-2012, 11:16 PM #3
- Join Date
- Nov 2012
11-10-2012, 11:51 PM #4
I'd reset it and see if it helps.
11-11-2012, 11:36 AM #5
11-11-2012, 08:16 PM #6
I do not know. Search it on the site. I think you just need to disconnect the battery for a certain amount of time for the reset, easiest would be to have the tuner that was used to restore factory settings if removing the battery for a couple hours doesn't work just go to Chevy and ask them to reset it. I know that may cost a lot possibly and be a hassle but it maybe only way. Also depending where you live some one from the site may be able to help you out.
By 4x4squared in forum Chevy C/K Truck ForumReplies: 4Last Post: 06-18-2012, 01:34 PM
By 558595 in forum GM PowertrainReplies: 2Last Post: 12-31-2010, 04:58 AM
By fwest3975 in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 05-30-2010, 11:19 PM
By maw454 in forum GM PowertrainReplies: 1Last Post: 02-25-2009, 04:29 PM
By 83Sub in forum Chevy C/K Truck ForumReplies: 9Last Post: 11-26-2008, 09:17 PM