Results 1 to 4 of 4
11-30-2012, 05:18 PM #1
How to get to the power mirror pad underside for cleaning?
My power mirrors do not work at all, and it was recommended that i thoroughly clean the contact area on the pad. I have removed the cover/trim, and pulled connection, but cannot see how to get the switch separated from the pad (or, how to get to the pad to clean it). Ideas????
12-01-2012, 07:40 AM #2
- Join Date
- Feb 2011
- Western Massachusetts
- Blog Entries
12-01-2012, 09:50 AM #3
Besides just cleaning it, (however you get it off) you should make sure you're getting power to the switch..00 Chevy Tahoe LT, 5.3 4x4
12-01-2012, 05:35 PM #4
I did this about 6 yrs ago. took about a half hour. no tools required . this all snaps together.clean the circuit board pad pick up with alcohol and a Q tip lightly.
best do this at warm temps. if you break it get new / no big deal.
if the mirror goes up not down etc this would be the pads dirty not a power / mirror issue.
By aka510 in forum GM Electrical TechReplies: 6Last: 11-19-2012, 12:51 PM
By parts bot in forum Chevy Parts eBayReplies: 0Last: 11-17-2012, 10:00 AM
By parts bot in forum Chevy Parts eBayReplies: 0Last: 11-16-2012, 11:30 PM
By estrozyk in forum GM Electrical TechReplies: 5Last: 10-28-2011, 07:17 PM
By brtt485 in forum General Chevy & GM Tech QuestionsReplies: 13Last: 08-15-2011, 01:24 AM
Tags for this Thread