Results 1 to 4 of 4
Thread: Chevy G20 shimmy
12-05-2012, 05:52 AM #1
- Join Date
- Dec 2012
Chevy G20 shimmy
My 1994 Chevy van developed a real bad shimmy a few months ago. I replaced the idler arm which was definitely bad but still drives like something is "out of round"? I changed both front tires and rims too. Could it be caused by a bad wheel bearing? It is much worse when braking but it occurs at all speeds. I'm thinking about getting a new rotor and bearings for the drivers side - that's where it feels like it is coming from. Just wondering if anyone else has had this problem. At this point it defintely feels unsafe to drive.
12-13-2012, 03:48 PM #2
Have you had your rotors resurfaced? That's the first place to start. Also, you may have brake caliper dragging. Take a real close look at both calipers and rotors to see if there's any sign of rust or damage.
Good Luck and God BlessRemember that if you're not part of the solution, then you're part of the problem!
12-13-2012, 04:21 PM #3
- Join Date
- Feb 2007
- Blog Entries
When replacing rotors or brake pads, ALWAYS replace them in pairs.Christopher
1991 Chevy Suburban 1/2 ton 2WD w/ chevy SBC 350-3/4 ton drivetrain upgrade w/4.10 gears 199K miles
2005 Saturn ION-2 Stock 255K miles
1982 Bronco, 1993 Bronco (sold), 1971 M35A2 Deuce and a Half
There are 10 kinds of people, those who understand binary, and those who dont...
Remember kids, the only difference between screwing around and science is writing it down- Adam Savage
01-01-2013, 02:06 AM #4
I had a bad tranny mount on my '85 G30 - acted a lot like that. Just a thought.
1999 Chevy K2500 Suburban 350
K&N, reworked cai, Thrush cat-backs
Vinyl, cranks, floor shift, and rear air!
By Shover56 in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 4Last Post: 12-14-2011, 10:47 AM
By R Runner in forum Lifted & Offroad SuspensionReplies: 0Last Post: 01-03-2010, 01:04 PM
By Ratt in forum Chevy Silverado Forum (GMC Sierra)Replies: 2Last Post: 12-28-2006, 11:29 PM
Tags for this Thread