Results 1 to 1 of 1
12-06-2012, 10:06 PM #1
- Join Date
- Dec 2012
6.2l nv3500 swap into k10 ?s and advice
so i have purchased my first chevy, 1986 k10 swb 400ci quadrajet 700r4 3.72 12 bolt rolling on 33x10.5 ($800). previous owner gave me another front diff with purchase, i figured out later b/c he had swapped the rear and left the front axle mismatched. he also told me that it was a 350. ran the numbers found out that it was a 1978 400ci. nice truck and all but i perfer diesel, especially idi diesel, for economy and waste oil potential.
i found a 1983 GMC 1500 2wd 6.2l with 63,000 original miles for cheep ($700) so i bought it. what i want to do is swap engines and sell the gmc to make some of my money back.
i know the motor mounts and bolt pattern for the trans are the same, they both have solid true dual exhaust. a good start to a project pile up.
then while cruising craigslist i found a nv3500 5 speed trans that was close and was able to trade for it.
now i am looking to make the 86 a 6.2l 5 speed 4x4.
i can will probably get a new flywheel and clutch b/c used ones are hard to come by/trust. but i am wondering about things like the starter and if the crank on the 6.2 has a hole for a pilot bearing? drive shaft lengths? fuel systems?
i plan on taking the sound deadening material and transplanting it as well as the diesel dash.
am i missing anything? has anyone ran this combo? etc etc
ps i know some think the 6.2l is gutless and bound to blow up. my daily driver at the moment is a 86 vw jetta 1.6l na diesel, thats gutless!
By Dart6pak in forum Chevy Truck Tech ForumReplies: 1Last Post: 10-20-2011, 07:03 PM
By amc401 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 10-28-2010, 09:04 AM
By Corverra in forum Chevy Silverado Forum (GMC Sierra)Replies: 1Last Post: 09-15-2009, 11:08 PM
By MTchevy1 in forum Chevy C/K Truck ForumReplies: 1Last Post: 07-20-2009, 09:41 AM
By Mean_Green_95 in forum GM PowertrainReplies: 0Last Post: 04-30-2009, 03:33 PM
Tags for this Thread