Results 1 to 9 of 9
Thread: p0171 p0174 '99 silverado
01-04-2013, 01:09 AM #1
p0171 p0174 '99 silverado
SES light comes on, throws the 2 codes. A lot of search results come up with, the trucks run poorly. In my case the truck runs fine. I just installed a fuel pump/filter. My dad actually just commented on how well it runs and sounds. I plan to clean the MAF tomorrow.
It does have an exhaust leak starting, so thinking that o2 sensor might be something.1999 Chevrolet Suburban LS K1500
1991 Chevrolet S10 4.3L 4x4
2005 Suzuki Forenza (GM/Daewoo)
01-04-2013, 08:17 AM #2
Airtex pump from az? Codes happen after change?01' 1500 LT Z71 ECSB 5.3L
line-x'd front brush guard with KC Daylighters, 6000k HID lows and highs, rewired highbeams, Trans-go mild shift kit, custom stainless duals, 3500 dually OEM taillights, K&N CAI. Still have OEM fender flairs and leveling kit in boxes waiting for time.
01-04-2013, 10:53 AM #3
with these codes when thrown at the same time is a vacuum leak. replace the PCV and make sure the hoses have no leaks cracks.
could also be air intake hose leaking after the MAF. intake manifold gaskets typical vacuum areas of a leak issue.
01-04-2013, 04:42 PM #4
Also today it was warmer than yesterday, and on my way to work the check engine light went off. Not sure if thats worth mentioning. I'm going to replace the PCV and clean the MAF today.
Is there any certain PCV that is recommended?
01-04-2013, 05:08 PM #5
most stores have ac delco.
make sure the pcv valve cover rubber fixture holds the valve securely.. check hoses before going to store including the other hose that the crankcase vents to the throttlebody area.
check that the dip stick is securely seated.
01-04-2013, 07:56 PM #6
This thing is loose.....
- - - Updated - - -
My local advance has a Wells, Purolator, and Fram in stock. Worth it to wait for an ac delco?
01-04-2013, 08:58 PM #7
- Join Date
- Dec 2011
- Blog Entries
Always worth the wait. AC Delco makes your oem parts that are built to last. Buy it on amazon if you can it will save some money.
1996 Chevy Tahoe LT 5.7L V8 4X4 202,000+ miles. Built proudly at Janesville Assembly in Janesville, Wisconsin
Basic mods: Lights all over, bunch of electrical work, and a couple cooling mods.
Check out my other mods in My Garage: http://www.gmtruckclub.com/forum/sho...t-Tahoe-4-Door
01-05-2013, 09:29 AM #8
I believe that is the vac solenoid valve for the fuel evap system. that hose should go to the fuel canister .
should be an O ring seal. may appear loose but as long as it has a seal it should be not leaking.
01-05-2013, 03:40 PM #9
I pulled it in the warehouse where I work and let it warm up, no fuel line chattering.
By N5856Z in forum GM PowertrainReplies: 4Last Post: 01-16-2013, 11:38 PM
By Suburban68 in forum Performance & FuelReplies: 4Last Post: 02-15-2011, 05:32 PM
By senorbob999 in forum GM PowertrainReplies: 0Last Post: 08-26-2010, 09:50 PM
By mkruluts in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 03-13-2010, 04:00 PM
By konger88 in forum GM PowertrainReplies: 8Last Post: 03-09-2010, 11:47 PM