so i bought some headlight tint film and completely failed on the install. i used soapy water, a squeegee, a hair dryer, and all my patience. one hour went by and i thought i did a great job... yes i thought. when i peeled off the outer layer i revealed many air bubbles i didnt see, and the edges started to peel up. damn. i tried but couldnt get te bubbles out, so i ripped it off and threw it away. next i started over and repeated all of what you just read.. anyone here have any better luck with this stuff or is this typical for someone without experience in tint film? if you did do it successfully, what did you do to get it to look good