Installing your GMTC Club Sticker

[Steve]

You have to be very careful when you get ready to put your Club Sticker on your window. Please note the following installation instructions. (My Trailblazer is in the shop still, so I'll put these on the Cavalier)

Step 1: Clean your window!





Step 2: Determine Layout. Where will the sticker go? Center top? Center bottom? Bottom left? Bottom Right?







Step 3: Peel off the THICKER-FEELING backing. You may be tempted to take off the thinner and somewhat translucent application tape, but you need to take off the backing!

-- IMPORTANT! PEEL OFF THE BACKING SLOWLY. Make certain that all of the letters stay with the application tape. If the letters stick to one side, stick it together again and pull from another direction. --

[Steve]

Step 4: Observe the reverse (mirror) image on the application tape.



Step 5: Apply to the window.

- Press down on the window, peel up the application tape slowly.







You're done! Enjoy showing your support for the club!

[GM_Guy]

those do look good!!

[Steve]

Thanks, the first batch has been mailed out, all you folks who get them need to post photos asap when you get them on your rigs!

There are still club stickers available, and I assume we'll order a 2nd batch once we go through those.

[chevyjeffgordon]

what size is that?

[Steve]

what size is that?

That's the Large size. It's 8" wide by 2 1/2" tall. I've got big hands, so it looks smaller than it would with someone with normal sized hands. lol.

[Steve]

Here's a couple of photos with a ruler...