GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4
  1. #1

    Talking 94 suburban cruise control

    The cruise control on my 94 1500 works fine but the speedometer goes crazy and bounces all over the dial when i engage it. Has anyone had the same problem? If so Where should i start to fix it?

  2. #2

    Default

    THATS A GOOD ONE! Is it factory cruise?

  3. #3

    Default factory cruise

    Yes it has a factory cruise mounted on the blinker. The speedometer will jump from the speed the cruise is set at to top speed and back very erratically. it never falls below the set speed.

  4. #4

    Default

    Man thats a good one! I dont know....Ive never heard or seen that one...Im thinking since your cruise is using the speed signal generated from your tranny, and its all good untill you engage the cruise, that MAYBE its R.F. interference....check your harness at the firewall. @ the cruise module, for cuts burrs ect. Is it too close to plug wires...Ect...?? Hard to tell with out seein that one. Check and move stuff around. Check the ground connections at your cruise module. And at the I.P. ( left side of dash, and steering column brackets.) CLEAN AND TIGHT! Good luck man.

Similar Threads

  1. Cruise Control WTF?!
    By GreatCaesar in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 16
    Last: 02-11-2011, 11:10 AM
  2. 07 Z71 - Cruise Control issue
    By JiggaJ429 in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    Replies: 0
    Last: 05-26-2010, 12:27 AM
  3. Cruise Control add-on?
    By jamesdeanj in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 6
    Last: 04-19-2010, 07:47 AM
  4. cruise control
    By TheUnit in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 11
    Last: 12-29-2009, 08:21 PM
  5. Cruise Control??
    By imthatgirl in forum General Chevy & GM Tech Questions
    Replies: 2
    Last: 03-01-2008, 10:24 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •