Results 1 to 1 of 1
02-11-2013, 06:57 PM #1
- Join Date
- Jul 2012
Installing coil springs on a 93 c1500 4.3l
I bought new control arms for my 93 C1500 4.3L. In fact, I am replacing the entire steering linkage also. 250k, I figured it was time to get a new ride out of the old girl. I have searched about 50 pages for a thread but to no avail.
I removed the driver side upper and replaced that with little to no problems, removed the lower and have been trying to install the coil spring back into truck with the control arm bushing bolts in position but not bolted. I have been using spring compressor (AZ Variety, bolt mounted from the shock hole on top of the axle with the spring holders hanging down inside the coil) and spring does not want to seat properly in the bottom pocket of the control arm when I jack it up from the bottom. I even tried to hammer it into place, but after a couple of whacks, it knocked off the compressor, figured that wasn't too safe.
Was wonder if I should remove the bolts that hold the control arm on and slightly bolt up the ball joint & knuckle and try it that way, or would that be an even bigger headache trying to get the bushing bolts to align with the fully compressed spring? If anybody out there has a surefire way to get this completed, I would greatly appreciate your help.
By BillM in forum Chevy Truck AccessoriesReplies: 4Last: 10-01-2011, 08:05 PM
By overton7 in forum Lifted & Offroad SuspensionReplies: 0Last: 10-16-2010, 09:47 AM
By 04-silverado in forum Chevy Silverado Forum (GMC Sierra)Replies: 19Last: 08-10-2010, 01:29 PM
By xjoedx in forum Lifted & Offroad SuspensionReplies: 4Last: 04-05-2010, 02:03 PM
By Chaser1 in forum Lifted & Offroad SuspensionReplies: 0Last: 12-07-2009, 12:01 PM