Results 21 to 24 of 24
Thread: '99 Silverado Passlock solution?
02-19-2013, 04:12 PM #21
Yeah, a very poorly installed remote start wiring job. When I was under there looking for the flasher relay I noticed everything was a cluster mess. Nothing was mounted where it was supposed to be, everything was just loose, wires everywhere.
I really wish I would have had time to work on it myself so I could get some experience doing that kind of work.1999 Chevrolet Suburban LS K1500
1991 Chevrolet S10 4.3L 4x4
2005 Suzuki Forenza (GM/Daewoo)
02-19-2013, 04:18 PM #22
I guess you did the correct thing by having , that shop fix up the hacked wiring. not a job for learning.
with what you stated on the condition , this needs time to make right.
many of these alarms/remote starts create many owner issues with this type install which is very common being screwed up.
good luck .
02-19-2013, 06:03 PM #23
02-25-2013, 06:08 PM #24
So far in the past few months this truck has had the fuel pump/filter, plugs/wires, intake gaskets, alternator, ignition switch, ignition lock cylinder housing, fuel pressure regulator, battery........I also have an upper ball joint and front shocks to install...oh and a new fog light to install......and replace the multifunction switch (no turn signals/flashers-already replaced the flasher relay). hm what else. I really should do a new slip yoke because of the annoying clunk.
By conman13 in forum GM Electrical TechReplies: 0Last Post: 09-29-2011, 07:41 PM
By jaden5012 in forum General Chevy & GM Tech QuestionsReplies: 4Last Post: 02-18-2011, 01:14 PM
By nj110 in forum Chevy Colorado Forum (GMC Canyon)Replies: 14Last Post: 05-24-2010, 07:09 AM
By aboston in forum GM Electrical TechReplies: 10Last Post: 01-05-2010, 06:49 PM
By EdPDX in forum General Chevy & GM Tech QuestionsReplies: 5Last Post: 01-06-2009, 10:51 AM