GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4
  1. #1
    Jr. Apprentice
    Join Date
    Feb 2013
    Location
    Bucks County, PA
    Posts
    10

    Default Please help! ABS light must go out!

    I found the problem code and repaired the wheel speed sensor. Afterwords re-scanned and no codes, but the ABS light is still on. I need to get the state inspection, my time is now out and I cannot drive the van on the road with an expired sticker. PA inspection will not pass when the ABS light is on and the shops charge over $100 to scan and turn off. I have an Actron with ABS reader that I was told would reset the fault codes and lights but there are no directions on how or if this can be done. Do I need a different scanner? I can exchange what I have now. If the battery was disconnected would that work?


    Rich

  2. #2
    Legend
    TRPLXL2's Avatar
    Join Date
    Jan 2009
    Location
    Norwalk, Ohio
    Posts
    3,357
    Blog Entries
    8

    Default

    What year of vehicle are we talking about?? If its newer 04+, disconnect the battery cables and holes them together for about 5 seconds then reconnect them. This resets the bcm, which is what controls the abs function.
    2004 Chevy Colorado
    LS1 5.7 swap/TBSS rear axle swap

  3. #3

    Default

    Actually, ABS has it's own computer, the BCM is not involved.
    Some codes can be reset by disconnecting the battery cables, however, the battery must be disconnected for at least 10 min.
    Depending upon the code, it may not reset.

    And, speaking about codes. A lot of code readers will ready PCM codes; but will not read a lot of other codes. ABS codes are usually not read by the inexpensive parts store readers.
    Ray

    '09 Avalanche LTZ - Black
    '05 Envoy XL (sold)

  4. #4
    Jr. Apprentice
    Join Date
    Feb 2013
    Location
    Bucks County, PA
    Posts
    10

    Default

    I have the Actron 9580 series which does scan and read ABS. No directions for use, either in the package or the company web site. I will try the battery later today otherwise I'm stuck and I don't want to buy a $2000 scanner just to turn off a light.

Similar Threads

  1. Replies: 0
    Last Post: 01-02-2013, 02:40 AM
  2. Replies: 0
    Last Post: 11-15-2012, 10:00 PM
  3. Replies: 0
    Last Post: 11-05-2012, 01:50 AM
  4. Tail Light/ Head Light Smoked Tint Finally pulled the trigger for $40!
    By Rockstarrchevy81 in forum Chevy Truck Accessories
    Replies: 8
    Last Post: 09-24-2011, 01:47 PM
  5. 99 Tahoe weird tail light/brake light/hazard light/blinker problem NEED HELP
    By beckya99 in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    Replies: 0
    Last Post: 07-11-2011, 10:46 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •