Results 1 to 3 of 3
03-25-2008, 02:30 PM #1
just looking for some advice.
I rebuilt the motor in my truck last year (SB 350, RV cam, crank, etc TBI) and I want to install new heads, and intake manifold. anyone have any suggestions as to what they have used or wanted to try?
1993 K1500 Suburban 350TBI, 378,486KMS on frame, 49,000KMS on Drivetrain. Lots of mods, built for haulin trailers and haulin @$$ :)
2000 K2500 Yukon XL 6.0L Vortec 252000KMS custom CAI, and exhaust...but not done yet.
"If you are dumb enough to do something you don't know how to do, and can't do it safely then WHEN you get hurt its your own fault...BONEHEAD"
03-25-2008, 08:44 PM #2
- Join Date
- Mar 2008
- WESTERN PA
I am not really used to dealing with the tbi setup everything we get into end up with a carb on itl. We run a set of vortec heads on a car we have I can tell you alot about them if you are interested. In my opinion top of the food chain for bolt on performance heads are the AFR heads I just seen their cnc ported new head it is just beautiful but it isnt cheap. Dart iron eagle platinum are a nice lower cost head.
03-25-2008, 11:18 PM #3
I would suggest lookin at edelbrock I know they make heads and intake/exhaust manifolds for the TBI motorsPETE
95 GMC Sierra 2500
3" Body Lift, 33" Goodyear MTR's
5.7L 350 TBI Edelbrock SDT Exhaust, Flowtech Headers, K&N Intake
1999 Jeep Cherokee, 3" Rustys lift, 33" BFG MT's, locked, armored: Rolled :(
2000 Jeep Grand Cherokee Limited. K&N Intake, Custom Kolak Exhaust
Contact this GMTC Moderator for any problems or questions you may have :great:
Join the GMTC Facebook Group!!! Join Here
By 94bluebeast in forum GM PowertrainReplies: 0Last Post: 06-12-2010, 08:37 AM
By daddytech in forum GM PowertrainReplies: 7Last Post: 05-29-2010, 03:30 PM
By BadBurban98 in forum GM Diesel & DuraMaxReplies: 1Last Post: 03-26-2010, 03:38 PM
By nos351wcm in forum GM PowertrainReplies: 0Last Post: 10-03-2009, 11:10 AM
By dwgmc1313 in forum GM PowertrainReplies: 2Last Post: 08-14-2009, 08:06 AM
Tags for this Thread