GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2
  1. #1

    Default 84 Silverado 350 auto...Swapping in an 87 Suburban 350 that was manual trans?

    We have an 84 silverado and the engine went, so we picked up a 350 out of an 87 suburban. The silverado is an automatic trans and the suburban was a manual trans. I was told the bearing in the back needed to be removed? The flex plate doesn't line up either. What else needs to be done? Any and all information is greatly appreciated!

  2. #2

    Default

    you can leave the bearing in there, its not going to hurt anything. The 1987 up blocks have a 1 piece rear main seal and have a different flex plate than the 1986 and down. You will need a flexplate for a 1987-up 5.7. These have a different bolt pattern and if I remember correctly they are externally balanced. The early 350`s are internally balanced.

Similar Threads

  1. '95 K2500 4x4 Suburban w/454 & auto trans. $3300.00 (So Cal)
    By Ricky B in forum GM Vehicle Classifieds
    Replies: 5
    Last: 10-10-2012, 09:37 PM
  2. Manual Trans in a 06 Silverado?
    By BlackJack1500 in forum General Chevy & GM Tech Questions
    Replies: 3
    Last: 10-25-2011, 12:41 AM
  3. 2002 4x4 Suburban auto trans problems
    By cabinetbuilder in forum General Chevy & GM Tech Questions
    Replies: 0
    Last: 07-27-2011, 11:09 AM
  4. Looking for help with swapping out engine/trans from one Sub to another
    By pinky in forum General Chevy & GM Tech Questions
    Replies: 0
    Last: 06-10-2010, 03:01 PM
  5. gm manual trans
    By surfer1316 in forum GM Powertrain
    Replies: 2
    Last: 02-04-2008, 08:24 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •