Results 11 to 12 of 12
Thread: Radiator Air Release valve
04-07-2013, 06:33 PM #11
the rad hose to remove would be the lowest one . this will cause the rad and about 1/2 of the engine to drain . some coolant will be trapped in the engine . remove hoses at the engine only for the heater core ,, then blow out the heater core, remove the plastic pressure tank and wash out .
the thermostat that I get has the goose neck/thermostat all one section not just the thermostat alone. cost last time was $23.oo USD. but this had a lifetime warranty.
I have had issues with this vehicle not getting up to proper temp. thermostat was defective.wanted to run at 180 deg f instead of 195deg f. quality parts are hard to find in today's Chinese world.
04-14-2013, 05:11 PM #12
I looked up the part for your vehicle . I would get the stant 14298 thermostat with the housing. I find it interesting that this is now with a 1 year warranty..... where I have the original sales receipt with the lifetime warranty. I guess they had a lot of issues with these ......
By Steve in forum Chevy Truck TalkReplies: 1Last Post: 07-29-2012, 02:40 PM
By phoebeisis in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 2Last Post: 12-21-2011, 01:20 PM
By Steve in forum Chevy Volt ForumReplies: 0Last Post: 03-02-2010, 08:50 PM
By bluecow24 in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 05-22-2009, 09:50 PM
By tt100 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 11-03-2008, 05:55 PM