Results 1 to 2 of 2
Thread: replace lifters or clean?
04-13-2013, 08:55 AM #1
- Join Date
- Aug 2011
replace lifters or clean?
2000 K2500 454 173k miles
Just need a few more answers on this subject. I've decided to give a cleaning one more try before I have to tear down the engine. So question 1: Should I try Seafoam in the oil or ATF? I am leaning toward Seafoam. How long should I leave it in? 500 miles? Right now I will have to drain some oil out because it is a quart overfull with the other additives that I put in already.
Question 2: Do the lifters need to be replaced or can they be cleaned? What causes them to go bad? Do they get dirty and just stick in the cylinder or is there a seal inside that leaks?
Money is tight, but I need my truck. If I need to replace them I will. Any help is appreciated, Thanks in advance. Andy
04-14-2013, 12:34 PM #2
1) Seafoam couldn't hurt. ATF will wash a lot of crud into the oil pump pickup, so I wouldn't recommend it.
2) As for causes, they usually just wear out. If they're stuck, the Seafoam should help. As for replacing them, they're pretty cheap. It's just a little time-consuming. But I'd try cleaning them and adjusting the rocker arms first....
By ninjaneer911 in forum Chevy C/K Truck ForumReplies: 2Last Post: 01-31-2012, 09:26 AM
By Bluewater in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 10-30-2011, 01:23 PM
By Chevyboy96 in forum GM PowertrainReplies: 4Last Post: 03-03-2011, 06:10 PM
By Lifted_Bowtie in forum GM PowertrainReplies: 10Last Post: 12-26-2010, 03:19 AM
By Bobby1021 in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 03-30-2010, 07:57 AM
Tags for this Thread