Results 1 to 7 of 7
Thread: P-0606 code Help?
04-15-2013, 05:51 PM #1
P-0606 code Help?
My light just came on. I ran up to Auto Zone to get a code. I got code P-0606.ECM internal fault. This is what I found. I don't know where the fuse is. I don't have a book. I will go out and check in a minute. Anyone have any experiences with this???
- Engine Control Module (ECM) Harness power supply circuit is open or shorted
- Engine Control Module (ECM) Programming
- Faulty Engine Control Module (ECM)
Help with this
Check the PCM fuse, if fuse is OK try erasing the code first and if the code comes back you may have to reprogram or replaced the PCM.
Help with this
When is the code detected?
Indicates the PCM has experienced an internal memory fault.
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine may not start
P0606 CHEVROLET Description
The Engine Control Module (ECM) continuously monitors its internal memory status, internal circuits, and output signals to the throttle actuator. This self−check insures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the code and illuminate the engine light.
Read more: http://engine-codes.com/p0606_chevro...#ixzz2QZiqixEI
Follow us: EngineCodes on FacebookTim Walters (Curky)
Wrangler AT/S 265/70R17 - Trail-FX window vents - Husky fitted splash guards - Silver Star zXe - Leveling kit -
04-15-2013, 06:58 PM #2
Start looking for shorts near the PCM ... frayed wires, +12v wires that have rubbed through and contacted metal, etc. :(
04-15-2013, 07:36 PM #3
- - - Updated - - -
I am going to take it to my buddy's work tomorrow. He is going to run for code again and reset it.
04-15-2013, 08:33 PM #4
It's under the hood, my buddy has an '04 and I think I remember seeing it on the driver's side. If you have an owner's manual, it should be in the pic of what's under the hood.
Sometimes, the problem is a loose/poor PCM ground. A lot of PCMs have been tossed out, when all that was wrong was a bad ground.Ray
'09 Avalanche LTZ - Black
'05 Envoy XL (sold)
04-15-2013, 10:33 PM #5
04-16-2013, 05:34 AM #6
04-16-2013, 12:59 PM #7
I did some research on it. It seems that many times a program flash or update will fix the issue. Most dealers charge around $135 to check what version program you have and then will upgrade it if you have an out of date program.
1995 Silverado 4x4
6" BDS Suspension Lift-3" Body Lift-Add A Leaf in rear -Trailmaster SSV Shocks-Duel Steering Stabilizer Kit -AirAid Cold air intake-
4.56 Gears with Detroit Auburn Locker-Pro-Comp Traction Bars with duel shocks-Aluminum Skid Plate Kit-38.5" x 16.5" Mickey Thompson Baja Claws-Constant Dropping fuel gauge
2005 Yukon XL Jet Power Programmer, Bilstein Shocks, Bilstein rear springs, Helwig Anti-sway bars, EGR Window Visors, EGR Hood Shield, Denali Headlights, Headlight harness upgrade, GE NightHawk Bulbs, White Night Rear lighting system, Russell Braided SS brake lines, PowerStop Brake pads, PowerStop cross drilled and Slotted Rotors, http://www.gmtruckclub.com/forum/sho...5-GMC-Yukon-XL
2002 Silverado ext cab 2wd (Sold)
2003 Yukon XL (Totaled)
By ncof300d in forum General Chevy & GM Tech QuestionsReplies: 3Last: 08-20-2012, 12:18 AM
By fnoblitt in forum Chevy Silverado Forum (GMC Sierra)Replies: 6Last: 11-12-2011, 11:35 AM
By danoo in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 2Last: 07-14-2011, 04:23 AM
By campuscop2003 in forum GM PowertrainReplies: 3Last: 08-06-2010, 10:08 PM
By MFR in forum Audio, Video & Gadget TechReplies: 4Last: 03-27-2008, 02:10 PM
Tags for this Thread