Results 1 to 6 of 6
Thread: floorboard for toolbox
04-18-2013, 04:56 PM #1
floorboard for toolbox
ill go ahead and mention @SurrealOne for the idea....
heres my neat little modification to my toolbox for some better storage to keep stuff from sliding around.
my toolbox before...
i cut up some 3/4" MDF...
sprayed it with rustoleum "bed liner" spray...
and heres the finished project...
bungee cords will hold my bottle jack firmly against the floor between the handles, and everything else is kinda stacked around it...
just a neat way to hold stuff to keep from sliding around...2000 Chevrolet Silverado
4.3L V6, 4L60E, 2WD, Single Cab
Poweraid TB Spacer
Flowmaster 10-series exhaust (dumped)
Edge CS insight monitor
LS-1 Dual Electric fans
Corvette tranny servo swap
Head Unit: Alpine
Speakers: Alpine SPR-60C 6.5" component set, 4X6 Infinity Kappas
Subs: 2-12" Kicker CVT's
Amps: Alpine-M1000 (subs), Alpine MRX-F65 (Speakers)
305/70R16 NITTO Terra Grapplers
16" PROCOMP 7089's
2" leveling kit
3" Fabtech Spindle Lift Kit
Front/Rear-Bilstein 5100 shocks
35W HID Low Beams
RECON LED smoked roof cab lights
HELLA LED taillights and 3rd brakelight
HELLA FF-75 Aux. Reverse Lamps
RIGID dually D2, flush mount, wide beam
Hawk HPS Brake pads
Russell braided steel brake lines
Powerstop-red powdercoated brake calipers
Powerslot Cryo brake rotors
EGR in-channel window visors
By Huntr in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 7Last Post: 10-08-2012, 08:16 AM
By hagarz71 in forum General Chevy & GM Tech QuestionsReplies: 10Last Post: 12-26-2011, 11:22 PM
By mbrooks17 in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 08-10-2009, 09:09 AM
By Breathtaker in forum Chevy Truck AccessoriesReplies: 5Last Post: 06-15-2009, 11:25 AM