GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4

Thread: Truck wont run

  1. #1

    Default Truck wont run

    I have a 1997 Chevy K1500 ext cab short bed Z71 with a 5.7L 350 Vortec I snapped a rod so I bought a new short block from a 1999 C1500 Suburban I got the it rebuilt and in my truck I replaced everything on the motor but now it wont run it will start and stay running as long as you hold the key in the start postion. I have replaced the Timing Chain, Crank Sensor, Ignition Coil, Distributor, Spark Plugs, Spark Plug Wires. I check all the fuses and they are all good.

  2. #2

    Default

    The ignition switch should provide 12 volts in 2 positions - hot in crank, - hot in run.

    The "hot in crank" 12 volts is only provided for the ignition circuit.

    The "hot in run" provides 12 volts for the ignition circuit and all vehicle accessories.

    We know the ignition circuit is ok, the engine runs if key is held in crank.

    So, is the problem with the ignition switch, or somewhere down-stream?

    When key is in the run position, will radio, heater, etc work?

    If no, problem is probably ignition switch; if they will work, the problem is in the circuit providing 12 volts to the coil when key is in run.

    On some vehicles, there is a resistor to reduce the voltage at the coil; if you have one, check the condition and the wires. The engine computer might do this on your vehicle (I don't have a wiring diagram).
    Ray

    '09 Avalanche LTZ - Black
    '05 Envoy XL (sold)

  3. #3
    Legend


    mfleetwood's Avatar
    Join Date
    Jul 2010
    Location
    Denver, CO
    Posts
    7,213
    Blog Entries
    1

    Default

    ****Merged duplicate threads and deleted duplicate posts******


    Mike (Denver, CO) - 2008 Sierra 1500 Z71 SLE 5.3L 4WD

    SUSPENSION: Rancho 4" Suspension Lift; Rancho RS9000XL Shocks; Rancho Skid Plates; Rancho MyRide Wireless Shock Controller;
    TIRES:
    BFG All Terrain KO 315/70/17
    DRIVE TRAIN: 4.56 Gears; Detroit TrueTrac Differential; True Cool 40k Transmission Cooler
    PERFORMANCE: DiableSport Predator Tuner; Custom Tuned by Diablew; Magnaflow Exhaust; AFE Cold Air Intake
    ELECTRONICS: Kenwood DNX6180 Touchscreen; Subthump box w/10" Kicker; Driver Information Center (DIC); Rear View Camera
    ACCESSORIES: Westin Brush/Grill Gaurd; Westin Nerf Bars; Truxedo Tonneau; 20% Tint; Tow Mirrors w/Heat & Signals

  4. #4

    Default

    when the key is in the run position everything works just not the motor

    - - - Updated - - -

    I figured out the issue I think since the truck is a 1997 and the engine is 1999 the Ignition switch is different and that is what is causing the issue Duralast/Ignition Switch

    For your 1997 Chevrolet Truck K1500 1/2ton P/U 4WD 5.7L SFI 8cyl
    Price: $149.99
    Part Number: LS931

    Duralast/Ignition Switch

    For your 1999 Chevrolet Truck C1500 1/2ton Sub 2WD 5.7L SFI 8cyl
    Price: $93.99 Part Number: LS947

Similar Threads

  1. Replies: 0
    Last: 03-18-2011, 10:00 AM
  2. Replies: 0
    Last: 03-11-2011, 02:50 AM
  3. truck wont start.........
    By NORMSCOLORADO in forum Chevy C/K Truck Forum
    Replies: 4
    Last: 04-08-2010, 01:09 PM
  4. My truck wont start
    By dustintreibel in forum Performance & Fuel
    Replies: 4
    Last: 03-11-2009, 11:58 PM
  5. 2006 silverado ignition wont switch wont turn
    By cgcomeaux123 in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 5
    Last: 12-01-2008, 04:05 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •