GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2
  1. #1

    Default Bent Torsion Bar Bolt

    Click image for larger version. 

Name:	IMG_0381.jpg 
Views:	82 
Size:	27.6 KB 
ID:	52942I went to go crank up my front end about an inch, and my left torsion bar bolt is bent up in the support bar. Is there a way to bend it back down on place, or will I have to buy a new one to adjust it?
    2000 Sierra Reg. Cab 5 Speed

  2. #2

    Default

    Unfortunately I would say replace. If you bend back you will weaken the bolt
    David
    2004 Silverado 2500 Crew Cab 4x4, AMSOIL EA air filter, Granatelli MAF sensor, Throttle body spacer, Magnaflow exhaust (true dual to 2 in 1 out muffler), 6" ProComp lift (add a leaf and 5" superlift rear block), Bilstein shocks, 35's (Cooper Disoverer ST) and 4.10 gears, Rhino Liner, EGRUSA fender Flares and widow visors, extended stainless steel brake lines, firestone airbags w/onboard air compressor, Pioneer Avic X940BT navigation, Accel backup camera.
    http://www.gmtruckclub.com/forum/sho...Silverado-2500
    1960 Land Rover Series II 88
    2001 Pontiac Sunfire
    2013 Toyota Avalon Limited (Wife's Car)
    NRA Life Member

Similar Threads

  1. Replies: 0
    Last: 04-11-2013, 04:00 PM
  2. Replies: 0
    Last: 11-25-2012, 12:30 AM
  3. Replies: 0
    Last: 08-30-2012, 08:30 PM
  4. Replies: 0
    Last: 08-14-2012, 08:10 PM
  5. Replies: 0
    Last: 07-28-2012, 05:00 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •