Results 1 to 8 of 8
07-30-2013, 04:47 PM #1
Yes! 33's will fit under a stock K1500
Yup, it's true. Just purchased and installed some 255/85/16 Bfg Mud Terrain KM2s. They actually measure 33.8x10.50. I previously had the torsion key turned a couple of times. I think it was equivalent to about 1.25 when I measured from the ground to the bumper. But it does not rub and it's not even close. Even when it's flexed.1998 K1500 Extended Cab Short Bed.
Z71-HD Chassis-Locker-3.73s-Skid Plates-3rd Door-Transmission Cooler-Tow Package-5.7L
Oh, you hate your job? Why didn't you say so? There's a support group for that; it's called EVERYBODY. They meet at the local bar.
ChevyFan liked this post07-30-2013, 09:52 PM #2
Looks good! And if they don't rub, then perfect!Clint (TX) 2001 Silverado LS 4.8L auto 2wd ECSB [GARAGE]
Gasoline or gunpowder: If you ain't burning one, you ain't having fun!
NRA Endowment Member 5 24 48 88 - Hendrick Motorsports FTW!
07-31-2013, 10:58 AM #3
- Join Date
- Dec 2004
- Arlington, Texas, United States
- Blog Entries
That looks very good. Where did you get them installed at?
10 Chevy Traverse LT AWD
02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
99 Chevy Cavalier LS (105K+ miles - commuter car)
78 Chevy Suburban Silverado (454, 3/4 ton)
62 GMC 3/4 ton Pickup (350 police interceptor)
Remember: Search Before Posting | Fill out Your Profile & Signature
* I've been saying for years that I was going to change my username, and I finally did.
07-31-2013, 11:10 AM #4
Lucky you! I've got a little rubbing issue. Nothing a dremel can't fix.
Looks good!2000 Silverado 5.3L Z71 4x4: K&N air filter, Procomp 16x8 rims, 285/70R16 Toyo AT2s, Kenwood head unit, Alpine 500.1 amp, 12" kicker, Infinity 5.25" speakers, Bilstein HD shocks, EBC GD Sport dimple & slotted front rotors w. EBC green stuff pads, Brembo slotted rear rotors & HIDs.
07-31-2013, 11:35 AM #5
Thanks again fellas, cheers
08-01-2013, 08:14 PM #6
wait, 255/80R16s stack up at 33"?.....
i though the conversion was 285/75/16 = 33"
thats what im thinking of getting to replace the 265/75/16 i have now. i think they come out to be about 31"
the trick seems to be to have aftermarket wheels with an offset. the stock wheels hug too close to the bodyGas was $1.83 when Obama took office.....
08-01-2013, 09:29 PM #7
Multiply the tire width by the percentage found in the aspect ratio, which is the second of the three numbers in the tire size. Using my tire, the sidewall is 85 percent of the width, or 8.533....
Multiply the sidewall width by two. This is necessary in determining the wheel's diameter because the sidewall is featured on both sides of the tire rim. That's 17.06 inches of sidewall...
Add the total side wall to your rim size 16. 33.06 x 10.039 r16.. My BFGs are just slightly larger cause of the lugs on the tire. But that math works for everything..
Ah you may not need new rims, the stock ones or aftermarket rims that have the similar offset actually clear better, unless you have like 12.50s and need the wide rim which needs the off set. But my 10.50s clear well even flexed
Last edited by CatastropheADJ; 08-01-2013 at 09:48 PM.
09-03-2013, 12:52 AM #8
- Join Date
- Aug 2013
Ive got 285/75/16 on my 97 k1500. No rubbing or anything.
Tags for this Thread