Results 1 to 4 of 4
09-12-2013, 04:33 PM #1
Spare Tire Release "plumbing" broke, how to lower tire? (spare tire kit)
Hey guys, my truck was hit from behind and the plastic tubing for the spare tire release/lowering is now removed from the system. Well my tire is flat and I need to lower that rim and put it on. How can I do this without the system? the bumper is jarred so the rod wont fit in there very well.
Also on a related note, i do have all the plastics (I think) to reinstall the system does anyone know off hand how to do this?
one last thing, the spare tire removal kit, do they sell these online? I think mine is only partial or incomplete, can I buy a new complete set or find out what the contents of the kit is so that I can compare mine to it?
Thanks in advance for the wonderful help,
09-12-2013, 05:06 PM #2
If your truck is an 04 like it says below your avatar then I don't think the plastic tube is really needed. It's just a guide to hep the rod get into the point needed to crank down the tire.
That being said, if the bumper is bent so much you can't get the rod through it, perhaps removing the bumper will allow you to access the spare?
As for the spare tire removal rod/tool, it should have 3 main rods plus the "handle" which should also be your lug wrench. Does your kit have less than 4 pieces?Clint (TX) 2001 Silverado LS 4.8L auto 2wd ECSB [GARAGE]
Gasoline or gunpowder: If you ain't burning one, you ain't having fun!
NRA Endowment Member 5 24 48 88 - Hendrick Motorsports FTW!
09-12-2013, 05:52 PM #3
dont buy the tool set, it is ridiculously expensive... i work at discount tire so thats how i got mine, but we use one piece tools for all spares, and it runs around $20.00, MAYBE you could walk in there and ask if they could order you one??? its a one piece design far superior to the overpriced 4 piece setups the stealership offers... it honestly makes everything way easier, and you just store it in your toolbox longways..... give that a shot see if your local discount tire would do that for you....2000 Chevrolet Silverado
4.3L V6, 4L60E, 2WD, Single Cab
Poweraid TB Spacer
Flowmaster 10-series exhaust (dumped)
Edge CS insight monitor
LS-1 Dual Electric fans
Corvette tranny servo swap
Head Unit: Alpine
Speakers: Alpine SPR-60C 6.5" component set, 4X6 Infinity Kappas
Subs: 2-12" Kicker CVT's
Amps: Alpine-M1000 (subs), Alpine MRX-F65 (Speakers)
305/70R16 NITTO Terra Grapplers
16" PROCOMP 7089's
2" leveling kit
3" Fabtech Spindle Lift Kit
Front/Rear-Bilstein 5100 shocks
35W HID Low Beams
RECON LED smoked roof cab lights
HELLA LED taillights and 3rd brakelight
HELLA FF-75 Aux. Reverse Lamps
RIGID dually D2, flush mount, wide beam
Hawk HPS Brake pads
Russell braided steel brake lines
Powerstop-red powdercoated brake calipers
Powerslot Cryo brake rotors
EGR in-channel window visors
09-12-2013, 06:12 PM #4
these bumpers bend easy. the steel re-enforcer piece if messes up could make this tough..may then have to drop the rear bumper assy.
Tags for this Thread