Results 1 to 4 of 4
Thread: picked out the lift kit!
09-30-2013, 11:44 PM #1
picked out the lift kit!
I've settled on a 2" body lift for my blazer... that will save me WAY more money in the long run than a suspension lift and a can still fit 33s with full travel. I have the 2" leveling kit from the torsion keys, and air-shocks in the rear to help with spring sagging under load.
The rest will just be the 2" body spacing... so if anyone has any advice on this id be happy to hear it!
this is the kit:
http://www.roughcountry.com/gm-body-...t-bl10022.htmlGas was $1.83 when Obama took office.....
10-01-2013, 04:14 PM #2
Looks like a good kit! Just don't forget to get an alignment done since you're maxing out the torsions. Don't mess up the steering extension and I'd find out if you need a fuel filler extension bc I didn't see one of those listed in the parts.Hotty Toddy!
10-01-2013, 08:47 PM #3
- Join Date
- Mar 2007
- Grand Prairie, Texas
- Blog Entries
Performance accessories is a decent kit.
Normally 2" wont need a fuel filler extension, if you do it as close as buying correct size fuel hose at a local auto parts along with clamps.
One extra I do on every body lift I put on is buying new fender washers and placing one under the bolt head and one between the body and puck, find the largest washer you can, something larger in size than the diameter than the pucks.
Check the rubber body bushings before starting and replace them if their checking or deteriorating.
One other item is 2" normally doesnt include bumper lifts, a good welder can fab brackets to lift the bumpers and keep them where they need to be on the body.
10-01-2013, 08:52 PM #4
"If you're not living life on the edge, You're taking up too much space"
"Truck Norris"- 2008 TX Edition Silverado
- McGaughy's 4/5 Drop Kit
- Apline Type R 10s & Amp
- Pioneer 6 Disc Touchscreen Deck
- Nightmare Breed Motorsports custom tune
- Custom 3" dual exhaust through x-pipe dumped at axle
- Airaid CAI
- Badges and molding removed, roll pan, Truxedo roll-up cover (compliments of GMTC!), 3pc billet grille, factory fogs upgrade
"Kristine" - 1991 Nissan 240sx
- Cut to pieces, LS build pending
Tags for this Thread