Results 1 to 5 of 5
10-29-2013, 07:26 AM #1
Best way to patch or fiberglass rust
I was looking at my rocker panels and there is a rust spot that is about to make a hole but whhat is the best way to fix that before it happens
10-29-2013, 10:22 AM #2
moved to maintenance & upkeep sub forum. changed title to make subject more clear.
1995 Silverado 4x4
6" BDS Suspension Lift-3" Body Lift-Add A Leaf in rear -Trailmaster SSV Shocks-Duel Steering Stabilizer Kit -AirAid Cold air intake-
4.56 Gears with Detroit Auburn Locker-Pro-Comp Traction Bars with duel shocks-Aluminum Skid Plate Kit-38.5" x 16.5" Mickey Thompson Baja Claws-Constant Dropping fuel gauge
2005 Yukon XL Jet Power Programmer, Bilstein Shocks, Bilstein rear springs, Helwig Anti-sway bars, EGR Window Visors, EGR Hood Shield, Denali Headlights, Headlight harness upgrade, GE NightHawk Bulbs, White Night Rear lighting system http://www.gmtruckclub.com/forum/sho...5-GMC-Yukon-XL
2002 Silverado ext cab 2wd (Sold)
2003 Yukon XL (Totaled)
10-29-2013, 12:24 PM #3
- Join Date
- Dec 2004
- Arlington, Texas, United States
- Blog Entries
How big are this rust areas? Small like a dime? Quarter? Larger?
There are a couple of ways to go about this. Everything from sanding and bondo to just covering it over with Diamond plate (I've got a buddy who that's all he would do...)
10 Chevy Traverse LT AWD
02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
99 Chevy Cavalier LS (105K+ miles - commuter car)
78 Chevy Suburban Silverado (454, 3/4 ton)
62 GMC 3/4 ton Pickup (350 police interceptor)
Remember: Search Before Posting | Fill out Your Profile & Signature
Follow Us Please: facebook.com/gmtruckclub | twitter.com/gmtruckclub
Support GMTC: Help the site, contribute today
10-29-2013, 04:55 PM #4
you will need a cut off wheel tool . you cut out all the rusted metal . then get some galvanized sheet metal and make a patch to fit. using a rivet tool/drill install rivets to hold in place. then use fiberglass reinforced bondo to cover the area. grind down so you get is level / kinda smooth. then use regular bondo to get the surface very smooth no pin holes. then prime/paint.
with rust coming thru the rocker you will have a good amount of metal to be replaced probably a 4 in X 12 inch section ...
10-29-2013, 06:21 PM #5
Your best bet is to cut out the rusted material, cut a patch of sheet metal the same size and weld it in. You then grind down the welds and finish with as little bondo as possible. A good body man can do it without using any bondo. Then epoxy prime and paint.
A quick fix is to grind the spot a bit, dent it in a little and fill it with short strand fiberglass, sand, prime and paint....
Depends on how long you want it to last
Tags for this Thread