Results 1 to 2 of 2
Thread: Safety lighting
08-09-2008, 05:27 PM #1
i have a 08 colorado and installing a switch box in the cab for the safety lights. need to know best way to run the power line from the battery to the inside of the truck
08-10-2008, 04:10 PM #2
- Join Date
- Mar 2007
- Grand Prairie, Texas
- Blog Entries
Why do you want to run a power line into the cab?
The switching system should be set-up with underhood relays, all power should go to the relay then to the light. The only wires from the cab should be a signal wire from the switch to the relay.
Light switches arent normally rated to take a lot of amps, if properly run through a relay they only see a minimal amount of amperage.
And as an added benefit the relays are normally closer to the power source and the end user, this in turn reduces line drop and helps the lights to burn brighter.
By BMP0014 in forum Chevy Truck AccessoriesReplies: 0Last Post: 05-29-2010, 01:21 PM
By jdickerson83 in forum Chevy Silverado Forum (GMC Sierra)Replies: 3Last Post: 08-09-2009, 10:26 AM
By drumrob in forum Chevy Truck AccessoriesReplies: 17Last Post: 03-16-2009, 05:58 PM
By nsdread07 in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 03-10-2009, 11:17 AM
By cascott325 in forum Chevy Truck AccessoriesReplies: 12Last Post: 09-16-2008, 10:54 PM
Tags for this Thread