Results 1 to 4 of 4
Thread: Power cable route
09-17-2008, 11:47 PM #1
Power cable route
I am wiring an amp in my 05 silverado and was wondering where the best place to route my power cable through the fire wall would be?
09-18-2008, 11:53 AM #2
there should be a boot or a groumet of some type there (usually on the driver side under dash, where the wires from the fuse box go through). if not, you might have to drill. i dont like drilling unless i absolutly have to. if you do, just make sure to check both sides for obstructions.
heres a couple tricks to get the wire through (might be a little gettoh, but it works):
if there is a boot, just unscrew your antenna off of the hood, poke it through the boot, tape your wire to it, then, pull out the oil dip stick, rub your finger on it and use it to lube the power wire where you taped it to the antenna, then yank it through. it should go right through!
Cody- Tulsa, OK
09-19-2008, 02:09 PM #3
when ever i have had to drill i always go right around the brake pedal, usually a very open area on the other side of the firewall and its easy to reach to drill99 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
09-22-2008, 01:01 PM #4
Ya I went through a gromet where the accelerator wires go through to the right of the brake cylinder if your looking from the outside.
By Steve in forum Other GM CarsReplies: 0Last Post: 12-18-2009, 05:22 AM
By smallblockfuelie in forum Chevy Silverado Forum (GMC Sierra)Replies: 6Last Post: 08-31-2009, 09:13 AM
By smallblockfuelie in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 08-12-2009, 08:12 PM
By IrishBrewer in forum Audio, Video & Gadget TechReplies: 0Last Post: 07-29-2008, 11:50 AM
By traci in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 2Last Post: 06-08-2006, 08:10 PM
Tags for this Thread