Results 1 to 5 of 5
Thread: Suspension Problem
11-17-2008, 09:27 AM #1
hi everyone, i already asked this in the silverado section with no response then i realized it belongs here lol. i have a 2000 2wd 1500 shortbed reg cab silverado. i was trying to decide to lift or to lower and went out to measure my truck to get an idea of what im looking at when i discovered that my truck sits 7/8" lower on the driver front than on the pass front. its also a little lower(9/16") on the driver rear than the pass rear. at first i thought busted shock? but then i got to looking on the net and found that a site called rockauto.com has spring sets designed to correct trucks that lean 1/2"-7/8" low on the driver front? now this makes me believe its common considering about 4 manufactures were listed and for sale including GM. does anyone know about this or heard of it? ..im 98% decided that i will lift my truck 2"-3" in the front rather than lower it but id like to sort this out first. any help would be appreciated.........
11-17-2008, 01:51 PM #2
I think if you gonna lift a 2wd truck you should put a 6 inch lift kit on it.
11-17-2008, 02:44 PM #3
I know that often it is the bed that is tweaked out of position relative to the cab but I don't know about driver / passanger elevation comparision.
Lift always looks better than lowering. I still can't figure out why my two of my buddies have lowered their trucks. They can't even pull into a parking lot without scraping the frame.Trevor - Huntington Beach, CA
2007 GMC 2500 4X4
11-17-2008, 11:38 PM #4
tlperry, yeah i know what you mean i had a v8 ranger for a while i got from my brother that was lowered and i actually got it stuck on a curb once lmao. craziest thing you ever seen. i wasnt going to really lower i was gonna just drop the back to level it. but since ive decided to lift the front no worries. im thinking the back of the truck is fine i think the back driver side is lower because the driver front is so low. 7/8" is quite a bit of difference. im just gonna have to assume that this was a factory problem on some trucks because of the fact you can buy spring kits to correct it. im thinking buying the springs to get it level along with 2" or 21/2" coil spacers for the front i might then need to raise the rear an inch or so to level it. not sure yet. id rather have the spindles but they are kinda pricey...........thanks for all the advice everyone......
11-18-2008, 12:08 AM #5
- Join Date
- Jan 2008
- Cheektowaga NY
By Steve in forum Other GM CarsReplies: 0Last Post: 01-27-2010, 02:40 PM
By Fear58 in forum General Chevy & GM Tech QuestionsReplies: 5Last Post: 12-13-2009, 06:38 PM
By CJlambertz71 in forum Lifted & Offroad SuspensionReplies: 4Last Post: 01-17-2009, 10:37 AM
By matt in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 13Last Post: 10-20-2006, 06:54 AM
By dal in forum The Coffee Shop ~ Chit ChatReplies: 1Last Post: 08-07-2005, 12:58 AM